AMBILIFE AMBILIFE 운영 매뉴얼 - 페이지 6

{카테고리_이름} AMBILIFE AMBILIFE에 대한 운영 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. AMBILIFE AMBILIFE 12 페이지. Photocatalytic air purifier

6.1.

Unpack the Appliance and check its completeness according to provisions of Chapter 4

(please refer to Table 2 at page 5) of this operation manual.

6.2.

Carry out visual inspection of the Appliance for possible damages, which may take place

during its transportation.

6.3.

If the Appliance has been stored in the cold room or transported at temperatures below

the freezing point, before switching it on the Appliance should be kept at a room temperature for at

least two hours in order to ensure condensate evaporation.

6.4.

It is recommended that Appliance should be installed on the horizontal or vertical surface

(please refer to Fig. 2 at page 7). Special holes are provided on the rear wall of the Appliance for

vertical mounting (please refer to Fig. 3 at page 7). It is not recommended to install Appliance near

the window and door openings, as well as less than 0.3 m distance from the walls or partitions.

7.1. Put power cord of the Appliance into 220 V socket.

In case of L-10016 models: After putting power cord into 220 V socket you will hear a long beep

and the Appliance will go into the standby mode (LED indicator flashes green).

Switch "I-0-II" in these models cannot be fixed. In order to switch on or off the Appliance you

should press «I» key. When the Appliance enters "Operation" mode, it will produce beep sound

(LED indicator will continuously light green).

LED indicator

Рower switch

Рower cord

7. Operation procedure

Figure 2

Figure 3