- ページ 2
医療機器 Ambu aScope 3のPDF クイックマニュアルをオンラインで閲覧またはダウンロードできます。Ambu aScope 3 2 ページ。 Intubation and single lung ventilation
Ambu aScope 3 にも： クイックマニュアル (2 ページ)
ページを印刷する
4.
Preparation for use
•
The aView can be placed on a flat surface or secured to an I.V. pole using the
bracket supplied. The bracket also has a hook that facilitates easy, accessible
storage of the aScope 3 via the hole in the top of the aScope 3/aScope 3 Slim pouch.
•
Most users find the default contrast and brightness settings to be optimal but
these can be adjusted if required.
•
Consider dimming the room lights to see the image from the aScope 3 or
aScope 3 Slim more clearly.
•
Check the battery indicator on the aView.
If the time remaining is not sufficient for the procedure charge the monitor by
plugging it into the mains.
5.
Icons
Start-up picture
Real time image will
appear after only a
few seconds.
After appr. 45 seconds
the user Interface is
ready displaying the
icons for battery status,
brightness/contrast
control, device usage
time as well as the as
snapshots and
recording of videos.
6.
Insertion of the aScope 3 & aScope 3 Slim
•
The tube connection can be used to fixate
the selected ET tube during intubation.
•
Keep the cord of the aScope 3 or
aScope 3 Slim as straight as possible by
holding the handle of the aScope 3 high.
This increases the range of movement of
the tip and allows you more control.
•
Advance the aScope 3 or aScope 3 Slim
slowly, allowing the light intensity of the
image to re-adjust.
•
If the image is affected by blood or
secretion you can try to clear the
secretion by flicking the bending lever up
7.
Removal procedure
•
Slowly withdraw the aScope while observing the image on the monitor.
The distal tip must be in a neutral and non-deflected position.
•
After use disconnect the aScope from the aView and dispose of it in accordance with
local guidelines for collection of infected medical devices with electronic components.
•
Wipe down the aView as per the instructions in the Instructions For Use.
Ambu A/S
Baltorpbakken 13 • DK-2750 Ballerup • Denmark
T +45 72 25 20 00 • F +45 72 25 20 50
www.ambu.com
When the aView is
turned on the ON/OFF
button will light up
green. During charging
the ON/OFF button will
light orange.
If the battery is fully charged and still
connected to a charger the battery
icon changes to:
and down or dabbing the camera tip
gently against the mucosal wall to clear
the image.
•
If the above fails, remove the aScope and
rub the lens clean with either gauze or an
alcohol swap.
Do not be afraid to exert a little pressure
when doing this. Proceed as above.
Max. battery status
Min. battery status
of the aView
of the aView
Battery current
Battery is charging
capacity
The icon remains white until one block is
left, after which it turns red.
When remaining battery capacity is 10%
the red battery icon starts flashing.
Charging is shown with blocks flashing.
Current capacity is shown with non-
flashing blocks.