- ページ 5

アンプ AMC 25100のPDF 設置および操作マニュアルをオンラインで閲覧またはダウンロードできます。AMC 25100 8 ページ。 Multi-channel power amplifier
AMC 25100 にも：設置および操作マニュアル (8 ページ), 設置および操作マニュアル (8 ページ)

ページを印刷する

REAR PANEL CONNECTIONS

1. MAINS INLET

Connect the AC line cord in to the mains inlet

and plug the AC cord plug into a nearby wall

outlet that provides the correct AC power line

voltage.

2. INPUT LEVEL CONTROLS

Each channel of the 2N100-5/25100 has its own,

independent level control. Before turning on the

2N100-5/25100 for the first time, make sure that

all level controls are set to their fully clockwise

position. These controls can be used for various

functions. For example, they can be used to

match the levels of loudspeakers in a multi-room

installation, or to lower the sensitivity of the

power amplifier, so that the volume control on

pre-amplifier is at a more convenient and usable

position. They can also be used to optimise the

balance in a stereo system.

3. LINE OUTPUTS

Each input has an accompanying line output

which will pass the signal onto another amplifier

input or other line-level device.

4. LINE INPUTS

There are five RCA phono connectors on the

back panel that connect to the inputs of each of

the power amplifiers.

5. LOUDSPEAKER TERMINALS

The 2N100-5/25100 is equipped with binding

post type speaker terminals that are desiged to

handle the extremely high peak currents that this

amplifier is capable of giving. Connections from

these terminals to the loudspeakers should be

made with heavy-duty wire. Standard wire of 16

gauge or thicker is recommended especially if

low impedance loudspeakers are used.

FRONT PANEL CONTROLS

1. POWER SWITCH

The press button switch marked power can be

used to switch the 2N100-5/25100 on or off.

When the 2N100-5/25100 is switched on, the

small indicator above the power switch will glow

green.