- ページ 10
アンプ AMC XIA50seのPDF 設置および操作マニュアルをオンラインで閲覧またはダウンロードできます。AMC XIA50se 17 ページ。 Stereo integrated amplifier, headphones amp series
ページを印刷する
FRONT PANEL CONTROLS
1. POWER SWITCH
The amplifier is turned on by depressing
the power switch. The small indicator
above the switch will glow blue. Before
switching on, always set the volume
control to minimum to avoid damage to
your loudspeakers.
Note: Your AMC amplifier will play music
almost immediately after being switched
on. However, in common with other
audiophile products, the internal circuits
take some time to stabilize fully, and the
best possible sound quality may not be
obtained until the amplifier has had some
time (possibly an hour or two) to warm
up.
2. INFRARED RECEIVER
The infrared receiver for receiving the
infra-red signals from your remote
handset.
3. BALANCE CONTROL
The Balance Control adjusts the relative
levels of the left and right channels. A
detent at the 12 o'clock position marks
the point of equal balance. Rotation of the
Balance Control to the right (clockwise)
decreases the level of the left channel so
that only the right channel is heard.
Rotation to the left shifts the sonic image
toward the left speaker.
Adjust the Balance Control to produce a
natural spread of sound across the space
b e t w e e n t h e s p e a k e r s , w i t h a n y
monophonic sound (such as a radio
announcer's voice) appearing as a
p h a n t o m i m a g e c e n t e r e d m i d w a y
between them. Recordings often contain
small errors in channel balance, typically
no more than 2dB; but this is enough to
d e g r a d e s t e r e o i m a g i n g . S m a l l
compensating changes in the setting of
the Balance Control can significantly
improve the depth and stability of the
stereo image.
4. PHONES
The headphone socket will accept any
headphones fitted with a standard
1/4"(6.35mm) stereo jack plug. When
Headphones are in use, the output to
your loudspeakers will be cut and all the
amplifier's functions will operate as
normal.
Special Headphone Amp Design for all
Headphones and earphones available in
the market up to 600 ohms impedance.
With AMC proprietary soft clipping circuit
topology for delivery Vacuum Tube like
Sound.
5. BASS CONTROL
The Bass Control adjusts the relative level
of the low frequencies in the sound. The
electrical response of the amplifier is flattest
when the control is set in the detent or 12
o'clock position. Rotation of the knob to the
right (clockwise) increases the level of low
frequency sounds, and rotation counter-
clock-wise decreases their level. Adjust the
Bass Control to achieve the tonal balance
that sounds most natural to you.
6. TREBLE CONTROL
The Treble Control adjusts the relative level
of the high frequencies in the sound. The
response of the amplifier is flattest when the
control is set in the detent or 12 o'clock
position. Rotation of the Treble Control to
the right (clockwise) increases the level of
high frequency sounds, and rotation
counter-clockwise decreases their level.
Adjust Treble Control to achieve the tonal
balance sounds most natural to you.
8