- ページ 8
アンプ AMC XIA50seのPDF 設置および操作マニュアルをオンラインで閲覧またはダウンロードできます。AMC XIA50se 17 ページ。 Stereo integrated amplifier, headphones amp series
ページを印刷する
8. LOUDSPEAKERS
Your AMC amplifier is designed to drive
loudspeakers with a nominal impedance
of 4-8 ohms.
LOUDSPEAKER CONNECTIONS
The loudspeaker output terminals will
accept 4mm(banana)plugs, spade
connectors, pin connectors or bare wires.
Connect the negative side(usually black)
of your left hand loudspeaker lead to the
black terminal of the two terminals
marked "left" on the rear of your amplifier.
The other side of your left hand speaker
lead (the positive side or red) should be
connected to the red terminal marked
"left". Repeat this operation for the right
hand loudspeaker.
Your AMC amplifier is capable of
generating high peak currents, so all
connections must be checked to avoid
inadvertent short circuits and to ensure a
good clean contact.
UNDER NO CIRCUMSTANCES SHOULD
THE OUTPUTS BE SHORTED TOGETHER.
Such action will damage output circuitry
and is not covered by guarantee.
HEATSINK/VENTILATION REQUIRE-
MENTS
The heat produced by your AMC amplifier
during normal operation is dissipated by
an during normal operation is dissipated
by an internal finned heatsink. It is
perfectly normal for your amplifier to
becomes quite warm and to radiate heat
when in use, especially if it is run near full
power. However, if it becomes too hot to
touch, switch off at once and contact your
dealer.
It is very important that there is adequate
ventilation for the whole of the amplifier.
Do not place the unit on a rug or other
soft surface that it could sink into,
obstructing the air inlets on its underside,
and take care not to obstruct the outlet
grille on the top cover.
9. AC Selector (115V or 230V)
The AC Selector will be set to the AC
power voltage of your country from
factory. But in case if your XIA30se/
XIA50se is not received directly from
factory or you move from one country to
the other, the AC selector might be
set at different voltage. So, before plug
power cord into your wall AC outlet,
please
always
selector set to the voltage of
the country you will use the XIA30se/
XIA50se or not and set to correct
voltage. When the AC Selector is set
to 115VAC,
the XIA30se/XIA50se can be used in
countries with AC Power Voltage
between 110V and 120V. When the AC
Selector is set to 230V, the XIA30se/
XIA50se can be used in countries with
AC Power Voltage between 220V and
240V.
10.
AC RECEPTACLE
The AC RECEPTACLE is for you to plug
in with power cord attached in the
packing or you can plug in with other
power cord with your preferences.
6
check if the Voltage