- ページ 4
室内暖炉 ACR Heat HERITAGE N25のPDF 据付・取扱説明書をオンラインで閲覧またはダウンロードできます。ACR Heat HERITAGE N25 10 ページ。
ページを印刷するINSTALLATION INSTRUCTIONS
IMPORTANT INFORMATION
This appliance must be installed in line with current building regulations
either by a registered installer or in conjunction with your local Building
Inspector. If in doubt, please consult your stockist or local planning
office.
If installed incorrectly, this appliance could contribute towards serious
accidents and / or damage to your property and could invalidate your
warranty.
The manufacturer's responsibility is limited to the supply only of this
appliance.
We recommend that a fireguard is used in the presence of children and
old and / or infirm people for safety.
The installaer should comply with Health & Safety regulations.
Adequate facilities should be provided for handling the appliance.
Extra care should be taken to avoid accidents and breakage of the glass
panels.
Care should be taken to avoid fire cement contacting the skin. The
material is caustic and in the event of skin coming into contact with the
fire cement, wash off immediately with clean water.
BEFORE YOU INSTALL YOUR APPLIANCE
Make sure the chimney is in good working order and that the
recommended required chimney draft is obtained. You must also ensure
that there is sufficient fresh air supply within the room as per Building
Regulations. If insufficient fresh air is provided, this will lower the
atmospheric pressure within the room and may lead to poor combustion
and smoke leakage from the appliance. We recommend that a minimum
airbrick of 33cm squared is installed (54cm squared for installations with
flue draft stabilisers)
The doors on your appliance have been accurately fitted in our factory. In
case you do find a problem in operating the doors, please report back to
your stockist now and do not continue with the installation until advised
further. ACR Heat Products can not accept responsibility for incorrect door
alignment once the appliance has been installed.
4