- ページ 7

室内暖炉 ACR Heat HERITAGE N25のPDF 据付・取扱説明書をオンラインで閲覧またはダウンロードできます。ACR Heat HERITAGE N25 10 ページ。

The inside of the stove is lined with vermiculite panels. These will break

under strong impact. Therefore, please ensure that when reloading your

stove, logs are placed onto the stove base rather than thrown to avoid

any breakages. The vermiculite panels are a "wear and tear" component

and are not covered by warranty.

FIRST FIRING OF APPLIANCE

During the first firing of your stove, the high temperature paint will cure.

This process will give off some smoke for a couple of hours depending on

the temperature of the fire.

This is perfectly normal but we do

recommend that you leave any windows and doors open for this period in

order to ventilate the room.

As part of the curing process, the paint will become soft during the

heating.

You should therefore be careful when touching the stove to

avoid damaging the paint finish or leaving any marks on it.

Ensure the protective plastic on the stove base has been removed before

attempting to light the fire. Open both sets of airslides fully and place

newspaper and kindling wood or firelighters onto the stove base and light

with a taper or match. Leave the doors slightly open. Allow the fire to

burn fiercely at this point in order to warm the chimney as quickly as

possible.

Gradually add larger logs until the fire is well established.

Close the doors at this point but keep both airslides in the fully open

position. When the fire is fully established, close down the primary air

slide and use only the secondary airslide to control the rate of burning.

For overnight burning, load the stove with logs and once well established,

close the doors and shut down both sets of airslides.

When using the optional solid fuel grate to burn smokeless fuels, we

recommend that you place either kindling wood and newspapers or

firelighters onto the grate and add a small amount of solid fuel to the

kindling.

Once lit, open both airslides and pull the doors together

leaving just a small gap. Gradually add more solid fuel to the grate until

the fire is established. The doors can now be closed and the secondary

airslide closed down. Control the rate of burning by using the primary

airslide.

RECOMMENDED FUELS