- ページ 13

実用車 Floe CARGO MAX XRT 8-57のPDF オーナーズマニュアルをオンラインで閲覧またはダウンロードできます。Floe CARGO MAX XRT 8-57 16 ページ。

ページを印刷する

maintaining Hub Lubrication

wHeel Hub lubriCation

Your hub/spindle is equipped with a lubrication system. The

bearings can be periodically lubricated without removing the

hubs from the axle. The advantage to this system is that new

grease saturates the inner bearing and outer bearing while

pushing out the old grease, unlike systems that just push new

grease on top of old grease.

1. Remove the rubber plug from the grease (hub) cap.

2. Use a standard grease gun on the grease fitting located at

the end of the spindle, or behind the hub, making sure the

grease gun nozzle is engaged on the fitting tightly.

3. Pump grease into the fitting, while slowly turning the

wheel. Grease will flow out of the hub around the spindle.

4. When the grease appears to be the new clean grease,

remove the grease gun and wipe off any excess grease.

5. Replace the rubber plug in the cap.

REmOvAL/REmOUnTinG FOR THE wHEEL HUb

Removing the hub for inspection or maintenance should be

done in a safe location away from moving vehicles.

1. Safely elevate and block trailer so that it will not move.

2. Remove the tire/wheel assembly.

3. Remove the grease cap from the hub by prying around the

edge of the cap.

4. Bend the locking tang washer to the "free" position.

5. Remove the spindle nut in a counterclockwise direction and

remove the spindle washer.

6. Remove the hub from the spindle. Be careful not to allow

bearings to fall out of the hub.

7. Clean bearing and cup surfaces, repack with lithium marine

grade grease.

8. Place hub on spindle in reverse order as listed above. Rotate

the hub while tightening the spindle nut to approximately

50 ft lbs. This translates into full hand pressure with a 12"

long set of pliers or 12" long wrench.

9. Loosen the spindle nut. Do not rotate hub.

10. Finger tighten the spindle nut until snug, backing out only

to line up the locking tang washer.

A complete inspection and greasing of wheel hubs is required

annually or every 2,000 miles, whichever comes first.

installing wheel Hub

11. Bend the locking tang tab in place.

12. Replace grease/hub cap.

13. Test hub with wheel mounted for excessive play or

tightness, readjust if required.

procedure for

- - - - - - - - - - - - - - IMPORTANT - - - - - - - - - - - - - -

procedure for