- ページ 15

実用車 Floe CARGO MAX XRT 8-57のPDF オーナーズマニュアルをオンラインで閲覧またはダウンロードできます。Floe CARGO MAX XRT 8-57 16 ページ。

ページを印刷する

wHat Can CauSe vibration in mY tow

veHiCle?

1. Over-tight hitch coupler -- See procedure for adjusting

hitch coupler earlier in this book.

2. Loose or worn wheel bearings -- See procedure for replacing

wheel hub earlier in this book.

3. Loose wheels -- See procedure for changing tires earlier in

this book.

4. New tires -- It is possible that the new tires are out of

round. Once they are inflated to the proper PSI and used

for a short period of time on a loaded trailer, they should

work themselves round. New tires that are still out of round

after an ample break in period may be defective and need to

be replaced. Call the tire manufacturer or your local FLOE

dealer for replacement.

5. Unbalanced wheel hubs -- If your tires are balanced and

not out of round this may be the problem. Replace if

necessary.

wHY DoeS mY trailer SwaY or wHip?

1. Trailer is not being towed level -- Refer to hitch selection

and use section of this manual.

2. Not enough tongue weight -- Refer to loading and unloading

section of this manual.

3. Overloaded trailer -- Refer to loading and unloading section

of this manual.

4. Too much tongue weight -- Refer to loading and unloading

section of this manual.

wHY are mY tireS wearing unevenlY?

1. Unequal side-to-side loading -- Refer to Proper Loading

and Unloading section of this manual.

2. Tires not inflated to proper PSI

3. Wheel bearings are not properly tightened & oiled.

Can i replaCe mY tireS witH larger oneS?

1. No, The Cargo Max was designed for use with 5.30 x 12"-C

tires and these may not be substituted for a larger size. A 12"

mag wheel upgrade is available.

Questions & Answers

wHy DO i kEEP bLOwinG FUSES wHEn i

ConneCt or uSe mY trailer ligHtS?

1. A wire is cut or bare and is shorting out -- Visually locate

and repair or replace.

2. Wrong size fuse in tow vehicle -- The trailer lighting system

draws 1/2 amp not taking into account anything else on this

circuit.

wHy DO my LiGHTS bLink On AnD OFF?

1. Corrosion on wire connections -- Check all connections

for corrosion, clean and apply electrical grease to prevent

future corrosion.

2. Improper or loose ground to tow vehicle -- This may cause

all lights to blink or cause your marker lights to blink when

you turn on your turn signals.

wHAT kinD OF GREASE SHOULD i USE in my

HubS?

1. High-quality high-temperature lithium wheel bearing

grease. Never use grease heavier than 265 A.S.T.M.

penetration (No. 2 grade).

For additional information, please contact your Authorized

FLOE Dealer, visit our website at www.floeintl.com or call:

1-800-336-6337 to locate the dealer nearest you.

Trouble Shooting

- - - - - - - - - - - - - - IMPORTANT- - - - - - - - - - - - - -