- ページ 8

計測機器 Flomec TM10NのPDF 製品取扱説明書をオンラインで閲覧またはダウンロードできます。Flomec TM10N 13 ページ。 Electronic water flowmeters

OPERATION / CALIBRATION

Verify Meter Accuracy

Before using, check the meter's accuracy and verify calibration.

1. Make sure there is no air in the system by starting the flow until it runs

steadily. Then, stop or divert the flow using a valve or nozzle

2. Meter an exact known volume into an accurate container. For best

results, meter with one continuous full stream.

3. Check the volume against the display or recording equipment. If the

amount metered is accurate, further calibration is not necessary. If not,

refer to the Q9 Owner's Manual (Non-Agency) Field Calibration Section

for further instructions (see below).

NOTE: Make sure you meet the meter's minimum flowrate requirements:

TM05 - 1/2 inch

TM07 - 3/4 inch

TM10 - 1 inch

TM15 - 1-1/2 inch

TM20 - 2 inch

You can download the Q9 Owner's Manual (Non-Agency) here:

or visit

technical documents.

TM Series Meter Minimum Flowrate

FLOMECmeters.com

1 GPM (3.8 L/min)

2 GPM (7.5 L/min)

5 GPM (18.8 L/min)

10 GPM (37.5 L/min)

20 GPM (75 L/min)

to download owner's manuals and other