- ページ 4

産業機器 AME Intl. 11001のPDF 取扱説明書をオンラインで閲覧またはダウンロードできます。AME Intl. 11001 6 ページ。 Aluminum otr 5 piece bead

Activating the Bead Breaker

The bead breaker uses a long stroke and high force. Be careful not to damage or bend rim

parts, such as the flange butt weld, when using the bead breaker.

Turn on the hydraulic pump to activate the bead breaker.

2. Apply enough hydraulic pressure to the bead breaker to push the flange about ½-3/4 inch [13-19

mm] from the lip of the bead seat band.

3. If the bead breaker moves and is no longer vertical, read just the ram adjusting screw. You must

release pressure before adjusting the screw.

4. Continue applying hydraulic pressure until the flange is about ¾ - 1 inch [19-25 mm] from the lip of

the bead seat band.

5. Place a nut or similar object between the flange and the lip of the bead seat band. (Fig. 4)

6. Release hydraulic pressure.

Continuing to Break the Tire Bead

1. Move the bead breaker away from the flange butt weld, 2-3 feet [0.5-

1.0 m from its present position.

2. Follow the steps in "Activating the Bead Breaker" above.

3. Continue advancing the bead breaker around the rim, 2-3 feet [0.5-

1.0 m] at a time, breaking the tire bead.

Stop breaking the tire bead when you have moved the bead breaker

about ¾ of the way around the rim. (Fig. 5)

To prevent damage to the rim, do not use the

bead breaker within 12 inches of the flange butt

weld.

5. Apply enough pressure to the bead breaker to completely

break the tire bead.

6. Release the hydraulic pressure.

NOTE: If you have gone all the way around the tire and the tire

bead does not break: Repeat the steps in "Activating the Bead

Breaker" and "Continuing to Break the Tire Bead" above, with more hydraulic pressure.

AME INTERNATIONAL

INSTRUCTION MANUAL

- 4 -