- ページ 6

ホットタブ Aero-Spa AP 1000のPDF インストレーション・マニュアルをオンラインで閲覧またはダウンロードできます。Aero-Spa AP 1000 13 ページ。
Aero-Spa AP 1000 にも：インストレーション・マニュアル (12 ページ)

Clear Protector Tube

4.) Lower the sintered diffuser into the hot tub and allow it to rest on

the bottom

5.) Locate the closest electrical outlet on the house or garage that is

at least 10' from the hot tub that can be used to supply power to

the equipment

6.) Insert the electrical plug from the Aero-Spa into provided cycle

timer. Adjust the timer to operate 2 hours of run time 2 times per

day. Adjust the timer based on your use habits. Reducing the run

time while maintaining water clarity will maximize the equipment

life and minimize power consumption.

7.) Insert the electrical plug from the cycle timer into a GFCI (Type 15-

5R) outlet. The equipment will begin to operate. You will hear a

faint hum from the generator and a steady bubble stream will be

emitted from the diffuser.

Grounding Instructions

This product must be grounded. In the event of an electrical short

circuit, grounding reduces the risk of electric shock by providing an

escape wire for the electric current. This product is equipped with a

cord having a grounding wire with an appropriate grounding plug

(type 5-15P). The plug must be plugged into an outlet (type 5-15R)

that is properly installed and grounded in accordance with all local

codes and ordinances. If repair or replacement of the cord or plug is

necessary, contact Aero-Spa, LLC or a qualified electrician. Check

with a qualified electrician or serviceman if the grounding instructions

are not completely understood, or if in doubt as to whether the

product is properly grounded.

Figure 3: Air Line installed in hinge with clear plastic

protector sleeve