- ページ 8

スチームクリーナー Euro-Pro S3325HのPDF オーナーズマニュアルをオンラインで閲覧またはダウンロードできます。Euro-Pro S3325H 8 ページ。 Canister steam cleaner 120v., 60hz., 1500 watts

ページを印刷する

OPERATING INSTRUCTIONS

Step 5: Slowly pour water using the

filling flask and funnel

provided into the boiler. DO

NOT Fill Under a faucet,

use the filling flask

provided. DO NOT

OVERFILL. Never put more

than 47 ounces (1400 ml)

of water in the unit at one

time.

Step 6: Screw safety cap back on to

the unit by turning clockwise

and press down to tighten

securely. Plug appliance

back into wall outlet. Steam

will start to be produced as

before.

Using Your Steam Cleaner with

Floor Brush

Step 1: Attach the two extension tubes to

each other by pushing

one onto the other

making sure that

they lock into

place.

(Fig. 2)

Fig. 2

Step 2: To attach the floor brush angle

adapter to the floor brush, hold

the floor brush with its bristles

down in your left hand. With the

floor brush angle adapter

pointing downward, insert it into

the hole in the back of the floor

brush, then turn the floor brush

angle adapter 180° counter

clockwise. (Fig. 3)

Fig. 3

Step 3

Attach the floor brush with

the angle adapter on to the

extension tubes.

Step 4: Attach the assembled

extension tubes to the nozzle

on the hose hand grip. Make

sure that the locking button

snaps in place.

Step 5: Insert the electrical power

cord into the wall outlet.

Press the On/Off button on

the unit to the "On" position.

The steam cleaner will now

begin to produce steam.

Heating time is approx. 10-

15 minutes with cold water.

Filling the steam generator

with hot water will shorten

the heat up time. When the

steam is ready, the steam

ready light will light up.

Floor Brush

The floor brush is equipped with a

carpet/floor selector. Turn the

carpet/floor selector button to the right

to raise the brush core to steam bare

floors or walls with towel in place.

Turn the carpet/floor selector button to

the left to release the brush core to

steam clean carpets or hard to clean

stains by using the bristles. (Fig. 4)

Fig. 4

Note: The floor brush may be used

with or without the towel.

OPERATING INSTRUCTIONS

Attaching a Towel to the Floor

Brush

100% white terry cloth towel can be fitted

on this brush, so as to absorb the dirt and

protect delicate surfaces.

Important:

Please note that bristles may

break through thin towels. To cut and make

your own towels, we recommend that you

use one (1) towel 8" x 17" folded in half or

two (2) towels 4" x 17" laid one on top of

the other be used. This will ensure that the

brush bristles do not break through and

that the towels will be sufficiently absorbent

and retain as much dirt as possible.

Very Important

: When installing the

towels to the floor brush, ensure that the

towels do not cover the front and the back

of the brush. (See Fig. 7)

In order to improve cleaning the floors

with the steam cleaner and leave the floor

drier, observe the following instructions:

1. Lay the towel flat on the floor.

2. Place the floor brush, centered on the

towel. (Fig. 5)

3. Fold the ends of the towel and clamp

ends under the towel clamps on the

floor brush. The above is easily

accomplished if the floor brush is

removed from the extension tubes.

(Fig. 6)

4. Clip the other side of the towel under

the other towel clamp as shown in

Fig. 7. When attaching the towel,

leave some slack. Do not pull tightly

around the brush.

5. Place the floor attachment on the

floor. Wait until the towel is hot, then

push slowly forward to clean the floor.

Most of the floor cleaning should be

done with the slow, forward

movement of the floor attachment.

Fig. 5

Fig. 6

Fig. 7

Important Note:

After using the towel

for some time the towel may become very

HOT. Care should be taken when

changing the towel. Wait until the towel

has cooled before changing it. Squeeze

the towel to take out the accumulated

water. Rinse in warm water or change the

towel completely.

Washing Instructions

Machine wash in warm, soapy water

using a mild detergent. If heavily soiled,

you may want to use bleach in the

washing machine.

Air dry ONLY. Do NOT dry in dryer.

Attaching the Accessory Adapter

To, attach the accessory adapter to the

connection nozzle on the hose hand grip,

push it in as far as it will go until you hear

it click in place. To remove the accessory

adapter, press on the locking button to

release it. (Fig. 8)

Locking Button

Fig. 8

Attaching the Concentrator Nozzle

To, attach the concentrator nozzle to the

accessory adapter, push it in as far as it

will go and turn it to the left to lock in

place. (Fig. 9)

The accessories (brushes, steam diffuser

with or without window squeegee) can

now be attached onto the concentrator

nozzle or it can be used alone. (Fig. 10,

Fig. 11)

Fig. 9

Fig. 10

Fig. 11