- ページ 17

エクササイズバイク Domyos VE 590のPDF 取扱説明書をオンラインで閲覧またはダウンロードできます。Domyos VE 590 20 ページ。
Domyos VE 590 にも：取扱説明書 (19 ページ), 取扱説明書 (19 ページ)

ページを印刷する

1. Lift the console out of its support, remove the battery cover located at the

back of the product, and place four LR14 (1.5 V) batteries in the battery

compartment behind the screen.

2. Make sure the batteries are installed correctly and are flush with the springs.

3. Put the battery compartment lid back on and check to ensure that it is secure.

4. If the display is illegible or incomplete, remove the batteries, wait 15 seconds

and then put them back in.

5. If you remove the batteries, the computer memory is erased.

RECYCLING :

LThe "crossed-out bin" symbol indicates that this product and

the batteries it contains cannot be disposed of with household

waste. They are subject to specific sorting. Take the batteries and

your unusable electronic product to an authorised collection area

for recycling.

Recycling your electronic waste will protect the

environment and your health.

- If you note abnormal distances or speeds, check that the switch

behind the console is in the VM position for magnetic bikes and

VE for elliptical bikes. Press the RESET button so that the change

takes effect.

- On magnetic bikes each turn of the pedals corresponds to a

distance of 4 metres, and on elliptical bikes 1 movements corres-

ponds to a distance of 1.6 metres. (These values correspond to

average distances on a bike or walking.)

- If the heart rate indicator (3,12,14) is not flashing or is flashing

erratically, check that your hands are positioned properly and that

the sensors are not too moist.

- If you note that the counter does not display the correct units of

distance, check that the switch behind the console is in the Mi

position to display in miles, or in the Km position to display in

kilometres. Press the RESET button so that the change takes effect.

E N G L I S H

BATTERY INSTALLATION

TROUBLESHOOTING

If the counter does not turn on :

- If you are using the battery: check that the batteries have been

placed in the correct +/- position.

- If the problem persists, start again with new batteries.

- If the bicycle is connected to the mains: check that the adaptor is

correctly connected to the bicycle.

- In both cases, check that the cables are correctly connected

behind the console and where the stem set joins the main frame of

the bicycle.

If the problem persists: Bring the product back to the nearest

DECATHLON store.

If a noise emanates from inside the casing or you cannot adjust

your intensity level when in manual mode, do not try to repair it.

Bring the product back to the nearest DECATHLON store.

Only use the product with the adaptor supplied.