- ページ 4

デジタルカメラ Canon XA10のPDF スタディ・マニュアルをオンラインで閲覧またはダウンロードできます。Canon XA10 12 ページ。 Canon xa10 hd camcorder
Canon XA10 にも：パンフレット＆スペック (2 ページ), ユーザーマニュアル (2 ページ), パンフレット＆スペック (2 ページ), クイックマニュアル (2 ページ), 基本設定 (4 ページ)

ページを印刷する

UHM Media Lab

2350 DOLE ST. KHET Studio B

WEB SITE: http://www.communications.hawaii.edu/mlab/about.htm

C. Demonstrate how to mount the camcorder on the tripod.

Before mounting the camcorder to the tripod, make sure that the tilt lock (2) and pan lock (3)

are locked and all leg extensions are secured so that the tripod does not move or collapse

when mounting the camcorder. After mounting the camcorder to the tripod, be sure to loosen

the pan lock (3) in order to avoid accidentally knocking the tripod over.

D. Demonstrate this basic safety procedure.

Always double check tripod stability prior to mounting the camcorder.

IMPORTANT NOTE: To avoid potential accidents with tipping the tripod over, never leave the

camcorder unattended, especially when tripod head (tilt lock) is in an unlocked position.

ALWAYS BE AWARE OF THE STATUS OF THE TRIPOD! To avoid damage to the tripod

head, never force a pan or tilt when the tripod head is in a locked position. This will cause

permanent damage to the tripod head!

POWERING THE CAMERA

Demonstrate two ways to power the camcorder

1. Battery power: Push a battery into the battery slot under the

viewfinder. Slide the battery upward (the triangle arrow at the top of

the battery points in the correct direction) until it locks into place.

Turning the camcorder on.

Remove the camcorder lens cap and press the "POWER" button to

turn the camera on. A green light will illuminate next to the ON/OFF

text. Open the LCD screen to see the picture. The battery level

indicator is on the upper right. If it isn't, push the "DISP. BATT

INFO" Button to bring it up. To remove the battery, turn the

camcorder off, slide the lever on the bottom of the camcorder

toward the front of the camcorder, and then slide the battery

downward and pull it out.

2. AC power: To avoid pulling over the camera, start by working from the wall

to the camera. Plug an extension cord into the wall. Plug a power strip into the

extension cord, making sure the power strip is turned off. Plug the AC power

adapter cord into the power strip. Plug the AC power adapter into the "DC IN"

plug on the camera. Turn on the power strip. The camera can now be turned on.

NOTE: The camera battery can be charged when the AC adapter is plugged

into the camera and the camera is turned off. The ON/OFF (CHG) light on the

camera blinks red to indicate that the battery is charging and it goes out when

the battery is fully charged.

Explain the situations in which a battery or AC power is used.

Batteries should be used for mobility such as when the camera is handheld or used for short

periods of time before setting up again. AC power should be used for extended setups when

camera is to be set up in one place for an extended period.

CANON XA10 Camcorder

UHM Media Lab Study Guide 8/17/2011

CANON XA10 Camcorder

Director's Phone: 956-3358

FRONT DESK: 956-3355

Page 4