- ページ 2

投影スクリーン Da-Lite Senior ElectrolのPDF 取扱説明書をオンラインで閲覧またはダウンロードできます。Da-Lite Senior Electrol 8 ページ。
Da-Lite Senior Electrol にも：取扱説明書 (8 ページ), 取扱説明書 (8 ページ)

ページを印刷する

When using your video equipment, basic safety precautions should always be followed, including the

following:

1. Read and understand all instructions before using.

2. Position the cord so that it will not be tripped over, pulled, or contact hot surfaces.

3. If an extension cord is necessary, a cord with a current rating at least equal to that of the appliance

should be used. Cords rated for less amperage than the appliance may overheat.

4. To reduce the risk of electric shock, do not disassemble this appliance. Contact an authorized ser-

vice dealer when repair work is required. Incorrect reassembly can cause electric shock when the

appliance is used subsequently.

5. The use of an accessory attachment not recommended by the manufacturer may cause a risk of

fire, electric shock, or injury to persons.

PRE-INSTALLATION

1. Carefully unpack screen and remove outer wrapping from case.

2. Remove instruction cover plate (Fig. 1). Do not remove metal shipping brace (secures roller), wrapping paper, or tape

strips until screen is installed.

3. Make sure to recheck measurement of screen location before installation.

NOTE: Screen is not centered in box. Screen surface is set 18

IRONING BOARD

Some Senior Electrols, depending on size and type of picture surface, contain an ironing board to flatten the fabric (long

strip attached). The ironing board is part of the screen. Do not remove or alter (Fig. 2).

INSTRUCTION COVER

INSTALLATION

HANGERS (If required)

1. Make sure one hanger is approximately 25" from end of case (motor end).

2. Make sure second hanger is approximately 11

3. Place a third hanger on the center line of fabric.

4. Make sure hangers are placed to fit into notches provided on screens equipped with an ironing board.

5. Make sure hanger used on motor end does not interfere with motor access door.

IMPORTANT SAFETY INSTRUCTIONS

SAVE THESE INSTRUCTIONS

CASE

FIG. 1

WALL TYPE HANGER

PICTURE

SURFACE

WALL OR CEILING MOUNT WITH HANGERS

Wall Type Hangers with ceiling hanger adapters are

standard equipment. For wall type, use wall hanger

only. For ceiling type installation, use the wall type

hanger and ceiling adapters as shown in Fig. 3 on

page 3.

⁄

" from motor end.

SHIPPING BRACE

(NOT ON 3" ROLLER)

IRONING BOARD

⁄

" from opposite end of case.

CEILING TYPE

HANGER

RECESSED ABOVE CEILING

PICTURE SURFACE

Other methods of installation will no doubt suggest

themselves especially in new buildings where it

would be an easy matter to provide a recess for the

screen to conceal it when not in use. DO NOT SEAL

IN–ALLOW ACCESS.

FOR EXPOSED INSTALLATION

If the screen is to be mounted in an exposed position,

it may be covered with finished plywood, veneer pan-

eling, plastic wall covering or a valance.

HEX HEAD

TAPE STRIP

SCREWS

FIG. 2

RAFTERS

PICTURE SURFACE