Da-Lite Senior Electrol Інструкція з експлуатації - Сторінка 2
Переглянути онлайн або завантажити pdf Інструкція з експлуатації для Проекційний екран Da-Lite Senior Electrol. Da-Lite Senior Electrol 8 сторінок.
Також для Da-Lite Senior Electrol: Інструкція з експлуатації (8 сторінок), Інструкція з експлуатації (8 сторінок)
Друкувати сторінку
When using your video equipment, basic safety precautions should always be followed, including the
following:
1. Read and understand all instructions before using.
2. Position the cord so that it will not be tripped over, pulled, or contact hot surfaces.
3. If an extension cord is necessary, a cord with a current rating at least equal to that of the appliance
should be used. Cords rated for less amperage than the appliance may overheat.
4. To reduce the risk of electric shock, do not disassemble this appliance. Contact an authorized ser-
vice dealer when repair work is required. Incorrect reassembly can cause electric shock when the
appliance is used subsequently.
5. The use of an accessory attachment not recommended by the manufacturer may cause a risk of
fire, electric shock, or injury to persons.
PRE-INSTALLATION
1. Carefully unpack screen and remove outer wrapping from case.
2. Remove instruction cover plate (Fig. 1). Do not remove metal shipping brace (secures roller), wrapping paper, or tape
strips until screen is installed.
3. Make sure to recheck measurement of screen location before installation.
NOTE: Screen is not centered in box. Screen surface is set 18
IRONING BOARD
Some Senior Electrols, depending on size and type of picture surface, contain an ironing board to flatten the fabric (long
strip attached). The ironing board is part of the screen. Do not remove or alter (Fig. 2).
INSTRUCTION COVER
INSTALLATION
HANGERS (If required)
1. Make sure one hanger is approximately 25" from end of case (motor end).
2. Make sure second hanger is approximately 11
3. Place a third hanger on the center line of fabric.
4. Make sure hangers are placed to fit into notches provided on screens equipped with an ironing board.
5. Make sure hanger used on motor end does not interfere with motor access door.
IMPORTANT SAFETY INSTRUCTIONS
SAVE THESE INSTRUCTIONS
CASE
FIG. 1
WALL TYPE HANGER
PICTURE
SURFACE
WALL OR CEILING MOUNT WITH HANGERS
Wall Type Hangers with ceiling hanger adapters are
standard equipment. For wall type, use wall hanger
only. For ceiling type installation, use the wall type
hanger and ceiling adapters as shown in Fig. 3 on
page 3.
⁄
" from motor end.
5
8
SHIPPING BRACE
(NOT ON 3" ROLLER)
IRONING BOARD
⁄
" from opposite end of case.
1
2
CEILING TYPE
HANGER
RECESSED ABOVE CEILING
PICTURE SURFACE
Other methods of installation will no doubt suggest
themselves especially in new buildings where it
would be an easy matter to provide a recess for the
screen to conceal it when not in use. DO NOT SEAL
IN–ALLOW ACCESS.
FOR EXPOSED INSTALLATION
If the screen is to be mounted in an exposed position,
it may be covered with finished plywood, veneer pan-
eling, plastic wall covering or a valance.
1
HEX HEAD
TAPE STRIP
SCREWS
FIG. 2
RAFTERS
PICTURE SURFACE