- ページ 2
ホームオートメーション Ekinex EK-GD2-DL-2-LVのPDF マニュアルをオンラインで閲覧またはダウンロードできます。Ekinex EK-GD2-DL-2-LV 6 ページ。 Dali 2 standard dimmers at 12 / 48 vdc with 1 / 2 - channels
ページを印刷する• Safety class II
• Weight 37 g
• Dimensions (LxHxP): 53 x 61 x 29 mm
Protections
The device is equipped with the following protections:
• OVP Over voltage protection
• RVP Reverse polarity protection
• OCP Open circuit protection
1) Control logic protection only
Control, signaling and connection elements
The devices are equipped with screw terminals for con-
necting the 12 / 48 Vdc input power supply (1), the output
loads (3) and the DALI bus (2). The EK-GD2-DL-1-LV
model is equipped with 2 poles for local control (5).
Both models have internal status LEDs (4a) and a
feedback button (4b) which, in the EK-GD2-DL-2-LV mo-
del, also allows the selection of DALI DT6 / DT8 mode.
The meaning of the status LED for EK-GD2-DL-1-LV and
EK-GD2-DL-2-LV devices is as follows:
• Green steady on: normal operation and DALI line pre-
sent;
• Green flashing: no DALI line;
• Flashing red: generic output error.
The button (4b) for EK-GD2-DL-1-LV activates the
feedback function, while for EK-GD2-DL-2-LV it allows
the selection of DT6 (1 or 2 channels) or DT8 Tunable
White.
4a
4b
1
EK-GD2-DL-1-LV
4a
4b
1
EK-GD2-DL-2-LV
1
1
2
3
5
2
3
Nr.
Label
Connection
1
DC IN (+)
DC (+) input
DC IN (-)
DC (-) input
2
DA
DALI pole 1
DA
DALI pole 2
3
LED OUT x (+)
Output x (+)
LED OUT x (-)
Output x (-)
4a
-
Status internal LED
4b
-
Feedback or DT6 / DT8 selector (**)
5 (*)
PUSH
N.O. pushbutton, pole 1
PUSH
N.O. pushbutton, pole 2
(*) EK-GD2-DL-1-LV only
(**) EK-GD2-DL-2-LV only
Accessory for 1 CH and 2 CH models
Rail-mounting support
The devices EK-GD2-DL-1-LV and EK-GD2-DL-2-LV
can be mounted on 35 mm rail (according to EN 60715)
with the plastic support included in the delivery.
Mounting
The devices have degree of protection IP10, and are the-
refore suitable for use in dry interior rooms. The 1 CH and
2 CH models are suitable for installation in wall-mounting
boxes. The plastic support allows mounting on a profile
rail according to EN 60715 inside electrical distribution
panels and cabinets.
Before removing the device, be sure that inputs, outputs,
and the DC power supply have been disconnected.
2