- ページ 3

アダプター Dongguan Binshi BTA007のPDF クイック・スタート・マニュアルをオンラインで閲覧またはダウンロードできます。Dongguan Binshi BTA007 6 ページ。

5、Clearing the pairing lists

After it is been changed the mode, it will clear the pairing information

left by the last mode.

Tips: after the clearing of the pairing information, please delete or

ignore the pairing information on the phone in case you fail to pair it.

6、Audio interface change

After it is been changed the mode, it will clear the pairing information

left by the last mode.

Tips: after the clearing of the pairing information, please delete or

ignore the pairing information on the phone in case you fail to pair it.

7、Reset

Short press the Reset key

8、Low battery and power off automatically

When the battery is low the red light will blink. When the voltage of

the battery is below 3.1V, the adapter will be power off automatically

9、 Charging

When you insert it into the Micro USB, the adapter will reset the

chipset first (can solve the problem of crash) and then charge itself.

10、Use under charging

When you insert the adapter to the socket, you can turn it on and

use the adapter normally. However, we don't advise to use this

function considering the life of the battery

11、 Multi-points supported function/ function of connecting two

devices one time

When you insert it into the Micro USB, the adapter will reset the

chipset first (can solve the problem of crash) and then charge itself

1) TX MODE

Choose TX mode after turn it on, and let the first Bluetooth device, say BYZ YS 008, get into

pairing mode (Long press the MFB button of YS008 at least 6 seconds until see the alternative

flash of red and blue light). The green light is on after successful pairing (supports APTX,

APTXLL green light is on and doesn't support blue light on). Double click MFB button of the

adapter, the green LED light of adapter blinks quickly, get the second Bluetooth device, say

BTA007, to enter into the pairing mode (Long press the MFB button of BTA007 until see the

alternative flash of red and blue light) wait several seconds, it will connect the second device

automatically. After successful connection, the blue LED light is on. Tips: when it connects two

devices, CODEC will automatically change into SBC mode because of the speed of transmission.

2) RX mode

Choose X mode after turn it on, turn on the first cellphone or another Bluetooth device, and

search and choose BTA007 to connect. After connected, double click the MFB button to

disconnect the first cellphone or other connect Bluetooth device and enter into the pairing mode

again. Make the second cellphone or another Bluetooth device enter into Bluetooth stage; search

and connect BTA007. After connection, turn on the first Bluetooth device and choose BTA007 in

your paired list to connect. And then two cellphones or other Bluetooth devices connect to the

adapter successfully.