- ページ 3
ネットワーク・ハードウェア Doodle Labs Smart RadioのPDF トラブルシューティングマニュアルをオンラインで閲覧またはダウンロードできます。Doodle Labs Smart Radio 16 ページ。 Advanced mimo mesh router for resilient private wireless networks
ページを印刷するSmart Radio Trouble-Shooting
Guide
Mesh Rider Interface
The Mesh Rider interface is the main wireless interface and is available on all Smart Radio
products. Because it uses a proprietary wireless protocol, it is only accessible from other Mesh
Rider devices. The Mesh Rider wireless interface can be configured in Mesh or WDS AP/Client
modes. The WDS AP/Client mode is a star network configuration where all traffic passes
through the AP. Clients may not directly communicate with one another except through the AP.
APs may not directly communicate with one another except over a wired backbone. In Mesh
mode, all devices are equal and communicate with each other or through other devices.
ETH0 Interface
ETH0 is a standard Ethernet interface and is bridged to the Mesh Rider Interface. You may use
the ETH0 interface for communications between different devices in the network and also to
directly access the radio itself (for device configuration for example).
ETH1 Interface
The ETH1 interface is a standard Ethernet interface not bridged to the Mesh Rider interface. It
is normally used for device configuration. It is possible to modify the interface so that it is
bridged to ETH0 if desired. Otherwise, this interface can be treated as redundant and for most
applications it does not need to be used.
USB Device Port
The USB Device port is a Ethernet over USB interface and can be connected to USB host ports
like those found on PCs, or USB OTG ports like those on Smart Devices. It is bridged to the Mesh
Rider interface. USB Devices can only communicate with USB Hosts and not with other USB
Devices.
USB Host Port
The USB Host port is setup as an Ethernet over USB interface and can be connected to USB
device ports or USB OTG ports like those found on Smart Devices. It is bridged to the Mesh
Rider interface. It's functionality can be extended by installing addition USB drivers on the
Smart Radio, like USB HID drivers. USB Hosts cannot communicate with other USB Hosts, only
with USB Devices.
WiFi Radio
The WiFi radio is bridged to the Mesh Rider Interface and provides standard WiFi connectivity
to devices such as PCs and Smart Devices. The default SSID is DoodleLabsWiFi and the password
is DoodleSmartRadio.
UART
The UART interface is not part of the IP network, however, it can be bridged to the IP network
using software built into the Smart Radio. The UART interface on the Helix Smart Radios
supports up to 115200 bps while other radios support up to 1 Mbps.
© 2021 Doodle Labs. All rights reserved.
Page 3
September 8, 2021