Doodle Labs Smart Radio 문제 해결 매뉴얼 - 페이지 3

{카테고리_이름} Doodle Labs Smart Radio에 대한 문제 해결 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Doodle Labs Smart Radio 16 페이지. Advanced mimo mesh router for resilient private wireless networks

페이지 인쇄

Smart Radio Trouble-Shooting

Guide

Mesh Rider Interface

The Mesh Rider interface is the main wireless interface and is available on all Smart Radio

products. Because it uses a proprietary wireless protocol, it is only accessible from other Mesh

Rider devices. The Mesh Rider wireless interface can be configured in Mesh or WDS AP/Client

modes. The WDS AP/Client mode is a star network configuration where all traffic passes

through the AP. Clients may not directly communicate with one another except through the AP.

APs may not directly communicate with one another except over a wired backbone. In Mesh

mode, all devices are equal and communicate with each other or through other devices.

ETH0 Interface

ETH0 is a standard Ethernet interface and is bridged to the Mesh Rider Interface. You may use

the ETH0 interface for communications between different devices in the network and also to

directly access the radio itself (for device configuration for example).

ETH1 Interface

The ETH1 interface is a standard Ethernet interface not bridged to the Mesh Rider interface. It

is normally used for device configuration. It is possible to modify the interface so that it is

bridged to ETH0 if desired. Otherwise, this interface can be treated as redundant and for most

applications it does not need to be used.

USB Device Port

The USB Device port is a Ethernet over USB interface and can be connected to USB host ports

like those found on PCs, or USB OTG ports like those on Smart Devices. It is bridged to the Mesh

Rider interface. USB Devices can only communicate with USB Hosts and not with other USB

Devices.

USB Host Port

The USB Host port is setup as an Ethernet over USB interface and can be connected to USB

device ports or USB OTG ports like those found on Smart Devices. It is bridged to the Mesh

Rider interface. It's functionality can be extended by installing addition USB drivers on the

Smart Radio, like USB HID drivers. USB Hosts cannot communicate with other USB Hosts, only

with USB Devices.

WiFi Radio

The WiFi radio is bridged to the Mesh Rider Interface and provides standard WiFi connectivity

to devices such as PCs and Smart Devices. The default SSID is DoodleLabsWiFi and the password

is DoodleSmartRadio.

UART

The UART interface is not part of the IP network, however, it can be bridged to the IP network

using software built into the Smart Radio. The UART interface on the Helix Smart Radios

supports up to 115200 bps while other radios support up to 1 Mbps.

Page 3

September 8, 2021