- ページ 8
ゲートオープナー DoorHan PCB-SHのPDF プログラミング説明書をオンラインで閲覧またはダウンロードできます。DoorHan PCB-SH 14 ページ。 Control board
DoorHan PCB-SH にも： プログラミング説明書 (16 ページ), プログラミング説明書 (12 ページ)
ページを印刷する
1. CONTROL UNIT DIAGRAM
1.1. CONTROL UNIT SCHEMATIC DIAGRAM
CAUTION! Wires in the cable shall be protected against contact with any rough and sharp parts. A ll connections shall
be performed only when the power is off.
CAUTION! If no devices are connected to PH CL and COM terminal, it is necessary to install a jumper between contacts
PH CL and COM.
Control unit LEDs
LEDs in bold type indicate the state when the door is stopped in the middle position.
LED
Program
The operation mode is selected
SWOP
Limit switch to open
SWCL
Limit switch to close
OP
CL
PHCL
STOP
Remote
Record of remote controller code
8
Function
OPEN command
CLOSE command
Photocells to close
STOP command
On
Flashes according to the selected mode of operation
Does not respond
Does not respond
On
On
Do not respond
Off
On
ELECTRICAL CONNECTIONS
Off
Responds
Responds
Off
Off
Respond
On
Off