DoorHan PCB-SH 프로그래밍 지침 매뉴얼 - 페이지 8
{카테고리_이름} DoorHan PCB-SH에 대한 프로그래밍 지침 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. DoorHan PCB-SH 14 페이지. Control board
DoorHan PCB-SH에 대해서도 마찬가지입니다: 프로그래밍 지침 매뉴얼 (16 페이지), 프로그래밍 지침 매뉴얼 (12 페이지)
페이지 인쇄
1. CONTROL UNIT DIAGRAM
1.1. CONTROL UNIT SCHEMATIC DIAGRAM
CAUTION! Wires in the cable shall be protected against contact with any rough and sharp parts. A ll connections shall
be performed only when the power is off.
CAUTION! If no devices are connected to PH CL and COM terminal, it is necessary to install a jumper between contacts
PH CL and COM.
Control unit LEDs
LEDs in bold type indicate the state when the door is stopped in the middle position.
LED
Program
The operation mode is selected
SWOP
Limit switch to open
SWCL
Limit switch to close
OP
CL
PHCL
STOP
Remote
Record of remote controller code
8
Function
OPEN command
CLOSE command
Photocells to close
STOP command
On
Flashes according to the selected mode of operation
Does not respond
Does not respond
On
On
Do not respond
Off
On
ELECTRICAL CONNECTIONS
Off
Responds
Responds
Off
Off
Respond
On
Off