- ページ 7

ゲートオープナー DoorHan SHAFT-120のPDF 設置および操作マニュアルをオンラインで閲覧またはダウンロードできます。DoorHan SHAFT-120 12 ページ。
DoorHan SHAFT-120 にも：設置および操作マニュアル (12 ページ)

ページを印刷する

5. 3-position control station or key-switch

(N.O. contact) (terminal block X1 and X2)

Connect 3-position control station to terminals

'OPEN', 'STOP', 'CLOSE' and 'GND'.

Important! If 3-position control station is not

used, install the jumper 'STOP' and 'GND'.

Key�switch

3�button control station

9. Programming of operator

9.1 Selection of operation logic

The logic is selected with jumpers on the control unit:

To set the required logic, set the jumpers according to the table:

Opening – Pulse

Closing- Pulse

Automatic closing is off

Opening – Pulse

Closing – Key hold-down

Automatic closing is off

(Remove the jumper JP1)

10. Adjustment of open and close positions.

10.1 Close position (red cam)

Coarse adjustment

•

Make sure, that the operator is fixed rigidly; put the gate in completely closed position.

•

Loosen the screws for coarse adjustment of red cams, then turn them so, that the micro-switches are pushed, then tighten the screws.

•

Open and close the gate, make sure, that the red cams push the micro-switch, and indicator DL3 on the control unit is dim.

Voltage: 220V

Jumper

8.1 Control unit connection

220V Jumper for selection

of supply voltage

380V Jumper for selection

of supply voltage

Transformer

External radio

receiver

Voltage: 380V

Jumper

OP ERATOR SH A F T -1 20 INSTAL LAT IO N AND OP E RAT ING MANU AL

Motor

Fuse

Supply voltage

3x380V 50 Hz

Jumpers

Closing

Opening

Stop button

button

Key�switch

3�position control station

Opening – Key hold-down

Closing – Key hold-down

Automatic closing is off

(Remove the jumper JP2)

Opening – Pulse

Closing – Pulse

Automatic closing is on

(delay 30 sec)

WIRING

Important! If there are no

End switches

safety devices, install the

jumper IR�GND

Photocells

Open

Common