- ページ 3

コントローラー AMERITRON SDC-105のPDF 取扱説明書をオンラインで閲覧またはダウンロードできます。AMERITRON SDC-105 11 ページ。 Automatic screwdriver antenna controller for all transceivers

rating. Connect the Red wire to a +12 VDC Supply. Use 16 gauge wire when

adding additional length.

2. Connect the Black wire to the negative of the power supply or chassis ground.

3. Connect the four prong Molex plug to the antenna. Note: Some antennas do

not have the correct plug to match the controller's plug. The mate can be order

thru Ameritron part number 13-TAR102-2. Or the plug can be cut off and hard

wire to the antenna. See pictorial for wire color and its functions.

Antennas that do not have a 4 pin plug. The plug can be cut

off. Use the chart below for wire color and its function.

WARNING: An RF choke must be placed around the control lines at

the antenna. The Controller may be damaged if an RF

choke is not used.

Motor Operating Voltage

This control unit is designed to operate with a screwdriver antenna that operates

on 12 volts. Some antennas operate on only 3 or 4 volts, a Dropping Resistor

can be used inline with the motor wires to bring the voltage down. Consult your

antenna manual or manufacturer for the operating voltage.

CONTROL CABLE

RED

BLACK

GREEN

WHITE

motor control

MOTOR WIRE

SENSOR