AMERITRON SDC-105 사용 설명서 - 페이지 3
{카테고리_이름} AMERITRON SDC-105에 대한 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. AMERITRON SDC-105 11 페이지. Automatic screwdriver antenna controller for all transceivers
페이지 인쇄
rating. Connect the Red wire to a +12 VDC Supply. Use 16 gauge wire when
adding additional length.
2. Connect the Black wire to the negative of the power supply or chassis ground.
3. Connect the four prong Molex plug to the antenna. Note: Some antennas do
not have the correct plug to match the controller's plug. The mate can be order
thru Ameritron part number 13-TAR102-2. Or the plug can be cut off and hard
wire to the antenna. See pictorial for wire color and its functions.
Antennas that do not have a 4 pin plug. The plug can be cut
off. Use the chart below for wire color and its function.
WARNING: An RF choke must be placed around the control lines at
the antenna. The Controller may be damaged if an RF
choke is not used.
Motor Operating Voltage
This control unit is designed to operate with a screwdriver antenna that operates
on 12 volts. Some antennas operate on only 3 or 4 volts, a Dropping Resistor
can be used inline with the motor wires to bring the voltage down. Consult your
antenna manual or manufacturer for the operating voltage.
CONTROL CABLE
RED
BLACK
GREEN
WHITE
3
motor control
MOTOR WIRE
MOTOR WIRE
SENSOR
SENSOR