- ページ 7

コントロールユニット DoorHan CV01のPDF オーナーズマニュアルをオンラインで閲覧またはダウンロードできます。DoorHan CV01 12 ページ。
DoorHan CV01 にも：設置および操作マニュアル (4 ページ), マニュアル (8 ページ)

ページを印刷する

1. GENERAL INFORMATION

CV01 control unit is designed for remote and stationary control of:

electrical locks;

sectional door operators;

electric drives for sunshades, window shutters and rolling doors;

lighting.

It can also be used to provide effective operation of other companies' drives with DoorHan remote controls and to automate

various devices.

2. SPECIFICATIONS

Parameters

Supply voltage

Maximum rated current, not more than

Maximum rated voltage

Fuse breaking capacity

Number of operated drives

Operating temperature

Electrical protection class according to GOST 27570

IP code (waterproof and dustproof ratings)

Type of control

Remote control, key-switch

Press the "Open" button

Press the "Close" button

Press and hold the "Open" button

for more than 5 sec

Press and hold the "Close" but-

ton for more than 5 sec

Multi-channel remote control

Press the "Open" button

Press the "Close" button

Press the "Stop" button

3. INSTALLATION

1. Remove the control unit from the packaging. Unscrew the four screws located on the device casing, and take off the cover.

2. Carefully unscrew the two mounting screws on the control board and remove it from the casing.

3. Make the electrical connections in accordance with fig. 1, 2, 3.

4. Carefully attach the control board into the casing using the two mounting screws and close the cover.

5. Ensure maximum protection of the device from dust and moisture during installation. Use cable entries to connect mounting

wires to the control board.

WARNING!

Ensure minimum distance of 50 cm between the device and the ground level.

Minimum distance between neighbouring control units should be 20 cm at least.

Take the receiver antenna out of the casing to ensure proper signal reception.

open

starts to close

–

starts to close

–

starts to close

–

starts to close

Table 1. Control unit technical characteristics

Table 2. State of the rolling shutter when operated with control unit

State of the rolling shutter

closed

starts to open

–

opens till the button is

starts to open

–

starts to open

–

GENERAL INFORMATION

Value

220 V, 50–60 Hz

4 A

220 V ± 10 %

4 A

-40...+70 °C

IP 54

is opening

stops

–

stops

released

closes till the button is

starts to close

–

starts to close

stops

is closing

stops

–

starts to open

released

starts to open

–

stops