- ページ 10

ドア開閉システム DoorHan PCB-SWのPDF プログラミング説明書をオンラインで閲覧またはダウンロードできます。DoorHan PCB-SW 20 ページ。 Control board
DoorHan PCB-SW にも：プログラミング説明書 (20 ページ)

ページを印刷する

1. ELECTRICAL CONNECTIONS

WARNING!

The cable wires shall be protected from contact with any rough and sharp details. Before attempting any work on the

control board (connections, maintenance), always turn off power.

1.1. CONTROL UNIT WIRING DIAGRAM

5 А

PE N L

E N L

220-240 V

50 Hz

1.2. CONTROL UNIT TERMINALS

1. Power input connectors (J1 terminal block)

~220–240 V. PE, N, L — power supply connectors.

PE — ground terminal

power (neutral)

—

power (line)

—

2. Electric motors and signal lamp connectors (J7 terminal block):

1-2-3. M1 (COM/OP/CL terminals) — connector for the first electric motor. It can be used for opening of one leaf (if a pass

door or one-leaf gate is automated).

4-5-6. M2 (COM/OP/CL terminals) — connector for the second electric motor. It cannot be used for opening of one leaf.

7-8. LAMP — output for signal lamp connection (230V~ 40 W max).

3. Connectors for accessories (J4 terminal block (9—19 terminals) and J3 terminal block (20—21 terminals))

9-10. S-B-S — «Full opening» command: closing the contacts of the device connected to these terminals results in total open-

ing and/or closing of two gate leaves.

To install several devices connect their NO contacts in parallel.

11-12. PED — «Pedestrian passage» or «Close» command: closing the contacts of the device connected to these terminals

results in step-by-step opening or closing of one gate leaf.

0,8 А

Transformer

COM OP CL

LAMP S-B-S

1 2 3 4 5 6 7 8 9 10 11

COM

М1

М2

FOTO

PED OP CL COM STOP +24V

13 14 15 16 17 18 19 20 21

(Normally

closed)

NO NC

Key-button

ELECTRICAL CONNECTIONS

S Lock

Photocells

GND

COM

GND

VCC

+24