- ページ 9

オール・イン・ワン・プリンター Canon PIXMA MX700 SeriesのPDF サービスマニュアルをオンラインで閲覧またはダウンロードできます。Canon PIXMA MX700 Series 44 ページ。 Office all-in-one printer
Canon PIXMA MX700 Series にも：クリーニング・マニュアル (7 ページ), ネットワーク設定マニュアル (32 ページ), 補足マニュアル (6 ページ), セットアップ方法 (2 ページ), パンフレット＆スペック (2 ページ), 技術情報 (2 ページ)

ページを印刷する

2-3. Fax Errors

For errors other than those listed below, please refer to the "G3 / G4 Facsimile Error Code List (Rev. 2)."

(1) User error codes

Error code

TX / RX

#001

#003

TX / RX

#005

TX / RX

#009

#012

#017

#018

#022

#037

#085

#099

TX / RX

#995

TX / RX

(2) Service error codes

Error code TX / RX

##100

##101

TX / RX Sender's modem speed does not match the receiving machine.

##102

##103

##104

##106

##107

##109

##111

TX / RX Memory error

##114

##200

##201

TX / RX DCN has been received in a method other than the binary procedure.

##204

##220

TX / RX System error (main program hang-up)

##224

TX / RX An error has occurred in the procedure signal in G3 transmission.

##226

TX / RX The stack pointer has shifted from the RAM area.

##229

##232

##237

##238

##261

TX / RX A system error has occurred between the modem and the system control board.

Document jam

Document is too long, or page time-over

Initial identification (T0 / T1) time-over

Recording paper jam, or no recording paper

No recording paper at the receiving machine

Redial time-over, but no DT detected

Auto dialing transmission error, or redial time-over

Call failed (no dial registration)

Memory overflow at reception of an image

No color fax function supported in the receiving machine

Transmission terminated mid-way by pressing the Stop/Reset button

During TX (sending): Memory transmission reservation cancelled

During RX (receiving): Image data received in the memory cleared

Re-transmission of the procedure signal has been attempted the specified number of times, but failed.

Fallback is not available.

EOL has not been detected for 5 seconds (or 15 seconds in CBT).

RTN or PIN has been received.

The procedure signal has been expected for 6 seconds, but not received.

Fallback is not available at the sending machine.

After DCS transmission, a signal other than DIS, DTC, FTT, CFR, or CRP has been received, and re-

transmission of the procedure signal has been attempted the specified number of times but failed.

RTN has been received.

A carrier has not been detected for 5 seconds during image reception.

DTC has been received even when there is no sending data.

The recording area has been locked for 1 minute.

The encoder control unit has malfunctioned.

The decoder control unit has malfunctioned.

The print control unit has malfunctioned.

Meaning

7 / 41