2-3. Fax Errors
For errors other than those listed below, please refer to the "G3 / G4 Facsimile Error Code List (Rev. 2)."
(1) User error codes
Error code
TX / RX
#001
TX
#003
TX / RX
#005
TX / RX
#009
RX
#012
TX
#017
TX
#018
TX
#022
TX
#037
RX
#085
TX
#099
TX / RX
#995
TX / RX
(2) Service error codes
Error code TX / RX
##100
TX
##101
TX / RX Sender's modem speed does not match the receiving machine.
##102
TX
##103
RX
##104
TX
##106
RX
##107
RX
##109
TX
##111
TX / RX Memory error
##114
RX
##200
RX
##201
TX / RX DCN has been received in a method other than the binary procedure.
##204
TX
##220
TX / RX System error (main program hang-up)
##224
TX / RX An error has occurred in the procedure signal in G3 transmission.
##226
TX / RX The stack pointer has shifted from the RAM area.
##229
RX
##232
TX
##237
RX
##238
RX
##261
TX / RX A system error has occurred between the modem and the system control board.
Document jam
Document is too long, or page time-over
Initial identification (T0 / T1) time-over
Recording paper jam, or no recording paper
No recording paper at the receiving machine
Redial time-over, but no DT detected
Auto dialing transmission error, or redial time-over
Call failed (no dial registration)
Memory overflow at reception of an image
No color fax function supported in the receiving machine
Transmission terminated mid-way by pressing the Stop/Reset button
During TX (sending): Memory transmission reservation cancelled
During RX (receiving): Image data received in the memory cleared
Re-transmission of the procedure signal has been attempted the specified number of times, but failed.
Fallback is not available.
EOL has not been detected for 5 seconds (or 15 seconds in CBT).
RTN or PIN has been received.
The procedure signal has been expected for 6 seconds, but not received.
Fallback is not available at the sending machine.
After DCS transmission, a signal other than DIS, DTC, FTT, CFR, or CRP has been received, and re-
transmission of the procedure signal has been attempted the specified number of times but failed.
RTN has been received.
A carrier has not been detected for 5 seconds during image reception.
DTC has been received even when there is no sending data.
The recording area has been locked for 1 minute.
The encoder control unit has malfunctioned.
The decoder control unit has malfunctioned.
The print control unit has malfunctioned.
Meaning
Meaning
7 / 41
Halaman Cetak