- ページ 38
オール・イン・ワン・プリンター Canon PIXMA MX850のPDF ネットワーク設定マニュアルをオンラインで閲覧またはダウンロードできます。Canon PIXMA MX850 43 ページ。 Multifunction brochure
Canon PIXMA MX850 にも： 補足マニュアル (6 ページ), セットアップ方法 (2 ページ), パンフレット (2 ページ)
ページを印刷する
- 1. Setup Outline
- 2. Setting up the Machine and the Computer (Windows)
- 3. Preparing for Setup
- 4. Installing the Software
- 5. Setting up for Use over Wired Lan
- 6. Setting up the Machine and the Computer (Macintosh)
- 7. Cannot Connect to the Machine (the Machine Is Not Detected)
- 8. Setting up the Machine Again for Use over Network
Cause
The network setup of the Card Slot
fails.
(Continued)
"The Card Slot is already mapped as Network Drive to this computer."
is displayed
Cause
The Card Slot has already been
mapped as the network drive.
"Cannot map any more drives, because all the drive letters are
assigned." is displayed
Cause
All drive letters are assigned.
36
Troubleshooting
Change the workgroup name to "WORKGROUP" following the procedure
below.
(1)Right-click My Computer, then select Properties.
(2)Select the Computer Name tab, then click Change.
(3)Change the workgroup name to "WORKGROUP", then click OK.
If the problem is not resolved, click Skip to complete the installation without the
network setup of the Card Slot. After installation is complete, to mount the Card
Slot using the Canon IJ Network Tool, refer to "Using the Card Slot over a
Network" in the User's Guide on-screen manual. To mount the Card Slot
manually, refer to "Cannot Mount the Card Slot" in "Troubles When Using the
Machine over Network" in "Troubleshooting" of the User's Guide on-screen
manual.
Make sure that a memory card is inserted in the Card Slot. If it is not inserted,
insert it.
Note
Depending on the Mac OS version, the authentication screen may appears.
If it appears, click OK.
If the problem is not resolved, click Skip to complete the setup without the
network setup of the Card Slot. To mount the Card Slot manually, refer to
"Cannot Mount the Card Slot" in "Troubles When Using the Machine over
Network" in "Troubleshooting" of the User's Guide on-screen manual.
The Card Slot is already available. Click OK to close the dialog, then click Next
on the Network Setup of the Card Slot dialog box.
Click Skip to complete the setup. After software installation is complete, remove
any drive letter and try the network setup of the Card Slot again using the
Canon IJ Network Tool. For details, refer to "Using the Card Slot over a
Network" in the User's Guide on-screen manual.
Action
Action
Action