- ページ 4

プール掃除機 Astralpool JetstreamのPDF 据付・取扱説明書をオンラインで閲覧またはダウンロードできます。Astralpool Jetstream 10 ページ。

3. Ensure the power supply switch is in the OFF position (see Fig. 4) and plug the cable from the robot

cleaner into the power supply (see Fig. 5)

4. Place the cleaner into the water. Turn unit side to side whilst in the water to allow air to escape from the

body and then let the cleaner sink to the bottom of the pool (see Fig. 6) Spread the floating cable over the

surface of the pool as evenly as possible making sure to avoid kinks or tangles. Reminder: do not add any

more cable than required to reach the far corner of the swimming pool.

5. Connect the power supply to a grounded power outlet and turn on.

Important: When storing the cleaner, ensure it is located in an area well protected and in a temperature range of

10 to 40 degrees Celsius. Failure to comply may result in loss of warranty.

CAUTION: Do not switch the pool cleaner ON if not fully immersed within the swimming pool. Operating the

cleaner out of water will cause severe damage immediately and will result in loss of warranty. Allow the cleaner to

remain in the pool for 15 – 20 minutes after the completion of a cleaning cycle to allow the motors to cool

adequately. Do not leave the cleaner in the pool all the time. Always remember to turn the power supply OFF and

unplug from the power outlet prior to removing the cleaner from the water.

Inst308 Jetstream Robotic Pool Cleaner Instructions V.08_12