Astralpool Jetstream Kurulum ve Kullanım Talimatları Kılavuzu - Sayfa 4
Yüzme Havuzu Vakumu Astralpool Jetstream için çevrimiçi göz atın veya pdf Kurulum ve Kullanım Talimatları Kılavuzu indirin. Astralpool Jetstream 10 sayfaları.
Sayfayı Yazdır
3. Ensure the power supply switch is in the OFF position (see Fig. 4) and plug the cable from the robot
cleaner into the power supply (see Fig. 5)
4. Place the cleaner into the water. Turn unit side to side whilst in the water to allow air to escape from the
body and then let the cleaner sink to the bottom of the pool (see Fig. 6) Spread the floating cable over the
surface of the pool as evenly as possible making sure to avoid kinks or tangles. Reminder: do not add any
more cable than required to reach the far corner of the swimming pool.
5. Connect the power supply to a grounded power outlet and turn on.
Important: When storing the cleaner, ensure it is located in an area well protected and in a temperature range of
10 to 40 degrees Celsius. Failure to comply may result in loss of warranty.
CAUTION: Do not switch the pool cleaner ON if not fully immersed within the swimming pool. Operating the
cleaner out of water will cause severe damage immediately and will result in loss of warranty. Allow the cleaner to
remain in the pool for 15 – 20 minutes after the completion of a cleaning cycle to allow the motors to cool
adequately. Do not leave the cleaner in the pool all the time. Always remember to turn the power supply OFF and
unplug from the power outlet prior to removing the cleaner from the water.
Inst308 Jetstream Robotic Pool Cleaner Instructions V.08_12
4