- ページ 13
スキャナー Canon 8400F - CanoScan Flatbed ScannerのPDF クイック・スタート・マニュアルをオンラインで閲覧またはダウンロードできます。Canon 8400F - CanoScan Flatbed Scanner 19 ページ。 Canon canoscan 8400f: quick start
Canon 8400F - CanoScan Flatbed Scanner にも： クイック・スタート・マニュアル (36 ページ)
ページを印刷する
2
Insert the film into the Film Guide.
• Hold the film by the edges with your fingertips to avoid getting fingerprints or dirt
on the film surface.
• Use a blower brush to remove any dust from the film, document glass or light source
unit.
• Do not block the calibration slot on the Film Guide when you are scanning film.
Colors will not be scanned correctly if the calibration slot is obstructed.
35mm Film Strip
Open the film holder on the film guide, place the film face down and close the film holder.
Align the Film Guide's tab with the FILM symbol on the document glass of the scanner.
• Place a black piece of paper over any gap to shield the light if you are inserting a film
strip with 5 or fewer frames, or if the edge of a scanned image appears whitened.
• Ensure that there is no gap between the edge of the film and the film guide on the
side near the calibration shot.
35mm Slides
Align the Film Guide's tab with the FILM symbol on the document glass of the scanner.
Place a slide or slides face down (correctly viewed from
below) in the Film Guide as shown in the diagram to the
right.
Film Holder
Scanning Film
Calibration Slot
13