- ページ 14

スキャナー Canon 8400F - CanoScan Flatbed ScannerのPDF クイック・スタート・マニュアルをオンラインで閲覧またはダウンロードできます。Canon 8400F - CanoScan Flatbed Scanner 19 ページ。 Canon canoscan 8400f: quick start
Canon 8400F - CanoScan Flatbed Scanner にも: クイック・スタート・マニュアル (36 ページ)

Canon 8400F - CanoScan Flatbed Scanner クイック・スタート・マニュアル
Scanning Film
120 Format Films
Open the film holder on the film guide, place the film face
down and close the film holder.
Align the Film Guide's tab with the FILM symbol on the
document glass of the scanner.
• Leave a gap of 5/8" (15 mm) or greater
between film strips when placing two or
more on the document glass.
• Ensure that there is no gap between the
edge of the film and the film guide on the
side near the calibration shot.
Using a Film Retainer Sheet
Curled film strips can stick to the document glass and cause
a pattern of rings called Newton Rings to appear on the
scanned image. If this occurs, scan using the supplied film
retainer sheet as shown in the diagram.
(A) Scan with the film retainer sheet inserted beneath the
film.
(B) If Newton Rings still appear after following Instruction
(A), turn the film strip over and place it in the film holder
with the film retainer sheet on top so that the film edges
are held down for scanning. Then preview the image in
ScanGear CS and click the [Mirror] button to reverse the
image before initiating the final scan.
To avoid damaging the film, always place
the glossy side (the side without an illustra-
tion) of the film retainer sheet against the
film.
3
Close the document cover.
• You can purchase the Accessory Kit for CanoScan 8400F (CSAK-8400F) if the protective
sheet or Film Guides are lost or damaged.
14
(A)
120 Format Film
Film retainer
sheet
With its glossy side
facing upward, slip
the film retainer
sheet under the film.
(B)
Hold the film edges
down by placing
the film retainer
sheet on top with
its glossy side facing
downward.
Film Holder