- ページ 7

スイッチ Ametek Magnetrol SOLITELのPDF 設置および操作マニュアルをオンラインで閲覧またはダウンロードできます。Ametek Magnetrol SOLITEL 13 ページ。

Front

56-601 Solitel Vibrating Rod Level Switch

3.0

Reference Information

3.1

SOLITEL is a simple and reliable device. However, care

must be taken to avoid impacting or damaging the vibrat-

ing probe.

In the event the SOLITEL stops vibrating, the following

procedure will identify if the problem is with the electron-

ic module or with the sensor:

Disconnect the wires going to the sensor. (Terminals 3, 4,

and 5). The following gives the expected voltage range

between the sensors.

If these voltage readings are not obtained, the electronics

are defective and need to be replaced. If these voltages are

measured, the problem is with the sensor.

NOTE: The probe and electronics must be matched to ensure

proper operation. Use the following procedure to match

the electronics and the vibrating probe:

1. Connect the wires from the sensor to terminals 3, 4, 5.

There will be two wires of the same color and one wire of

different color. The two similar wires go to terminals 4 and

5; the single wire goes to terminal 3.

2. If the potentiometer is labeled "density" turn to the low

position – if labeled "sensitivity" turn to the high position.

Note this potentiometer has a 270 degree turn.

3. Apply power to the electronic module.

4. Turn the electronic module over.

Rear

Figure 7

Terminals

Voltage

3 and 4

4 to 6 VDC

3 and 5

0.3 to 1.0 V C