- ページ 8

スイッチ Ametek Magnetrol SOLITELのPDF 設置および操作マニュアルをオンラインで閲覧またはダウンロードできます。Ametek Magnetrol SOLITEL 13 ページ。

ページを印刷する

➃

➀

➄

➇

➈

5. Connect a digital multimeter between points MP5 on the

back of the module and ground connection (terminal 3 on

the electronic module) or the body of the vibrating probe.

See Figure 7 on page 7.

6. Adjust potentiometer P2 on the rear of the electronic mod-

ule to obtain a voltage between 0.4 volts and 1.0 volts. The

reading should be as close to 1.0 volt as possible.

7. Grasp the vibrating section of the sensor with your hand.

The vibration should stop and the relay will change state.

8. Remove your hand from the sensor. The relay will

change state.

9. The electronic module and probe are now matched.

3.2

Agency Approvals

3.2.1 CSA

Model

VXX-D1BX-XXX

These units have been evaluated to the

applicable UL and CS standards. CS is

accredited as a NRTL (National Recognized

Testing Laboratory) in the United States.

NRTL/C

These units have been tested to EN 50081-2

and EN 50082-2 and are in compliance with

the EMC Directive 89/336/EEC.

3.3

Replacement Parts

Item

➁

➂

➆

➅

Approval

Class I, Div. 2

Groups , B, C, & D

Class II, Div. 1

Groups E, F, & G

Type 4X

Description

Base

Cover

Cover o-ring

Electronics module:

110 V C

24 VDC

Bracket

Probe o-ring

Snap ring

Sleeve

Probe

56-601 Solitel Vibrating Rod Level Switch

Part Number

004-9189-001

004-9105-001

012-2101-345

Z30-9011-001

Z30-9011-004

005-6680-001

012-2408-001

010-5138-001

004-0111-001

Consult Factory