- ページ 16

マザーボード Asus A7V-VMのPDF ユーザーマニュアルをオンラインで閲覧またはダウンロードできます。Asus A7V-VM 23 ページ。 Athlon/duron microatx motherboard
Asus A7V-VM にも：クイック・スタート・マニュアル (22 ページ)

2. HARDWARE SETUP

8) Audio Port Connectors (Three 1/8" GAME_AUDIO)

Line Out can be connected to headphones or preferably powered speakers. Line

In allows tape players or other audio sources to be recorded by your computer

or played through the Line Out. Mic allows microphones to be connected for

inputting voice.

9) Primary (Blue) / Secondary IDE Connectors

(40-1pin PRIMARY/SECONDARY IDE)

These connectors support the provided UltraDMA/66 IDE hard disk ribbon cable.

Connect the cable's blue connector to the motherboard's primary (recommended)

or secondary IDE connector, and then connect the gray connector to your

UltraDMA/66 slave device (hard disk drive) and the black connector to your

UltraDMA/66 master device. It is recommended that non-UltraDMA/66 devices

be connected to the secondary IDE connector. If you install two hard disks, you

must configure the second drive to Slave mode by setting its jumper accord-

ingly. Please refer to your hard disk documentation for the jumper settings. BIOS

now supports specific device bootup. (Pin 20 is removed to prevent inserting

in the wrong orientation when using ribbon cables with pin 20 plugged).

TIP: You may configure two hard disks to be both Masters with two ribbon

cables – one for the primary IDE connector and another for the secondary IDE

connector. You may install one operating system on an IDE drive and another on

a SCSI drive and select the boot disk through the BIOS

IMPORTANT:

UltraDMA/66 IDE devices must use a 40-pin 80-conductor IDE

cable for 66MBytes/s transfer rates.

A7V-VM

A7V-VM IDE Connectors

ASUS A7V-VM User's Manual

Line Out

Line In

1/8" Stereo Audio Connectors

NOTE: Orient the red markings

(usually zigzag) on the IDE

ribbon cable to PIN 1.

PIN 1

Mic