- ページ 37

プロジェクター Canon LV-5200のPDF オーナーズマニュアルをオンラインで閲覧またはダウンロードできます。Canon LV-5200 48 ページ。 Canon lv-5200: user guide
Canon LV-5200 にも：パンフレット＆スペック (2 ページ)

ページを印刷する

1. Connecting to Computer

Power management

This function turns the Projection Lamp off when this projector

detects a signal interruption and is not used for a certain period in

order to reduce the power consumption and maintain the Lamp-life.

(This projector is shipped with this function ON.)

The Power Management function operates to turn the Projection

Lamp off when the input signal is interrupted and any button is not

pressed over 5 minutes. This function operates as follows;

1. When any input signal is interrupted, "No signal" and the count

down display appears (for 5 minutes).

2. After counting down for 5 minutes, the Projection Lamp and the

READY Indicator are turned off. (Cooling Fans keep running.)

3. The READY Indicator starts to flash after cooling down the

Projection Lamp about for 90 seconds (Power Management

mode).

In this Power Management mode, the Projection Lamp is

automatically turned on when the input signal is connected or

the projector is operated with any button on the Top Control or

on the Remote Control Unit again.

On start

When this function is "On," the projector is automatically turned on

just by connecting the AC Power Cord to an AC outlet.

NOTE : Be sure to turn the projector off properly (refer to the section

"TURNING OFF THE PROJECTOR" on P19). If the

projector is turned off in the wrong steps, the On Start

function does not operate properly.

Lamp mode

When selecting the "

" (Silent), the projector reduces the

brightness and sets into the low power consumption mode.

Remote control

This projector has two different remote control codes; the factory-set

normal code (Code 1) and the secondary code (Code 2). This

switching function prevents remote control interference when

operating several projectors or video equipment together.

When operating the projector in "Code 2," both the projector and the

Remote Control Unit must be switched to "Code 2."

To change the code of the Projector;

Set the Remote control in the SETTING Menu to "Code 2."

To change the code of the Remote Control Unit;

Press both the MENU and the IMAGE buttons on the Remote

Control Unit together for over 10 seconds.

After changing the code, make sure the Remote Control Unit

operates properly.

To return to the normal code (Code 1), repeat the steps above.

NOTE : When the batteries of the Remote Control Unit are replaced

or ALL-OFF switch is turned to "ALL-OFF," the remote

control code automatically returns to the normal code (Code

1).

Lamp counter reset

This function is used to reset the Lamp Replace Counter. When

replacing the Projection Lamp, reset the Lamp Replace Counter by

using this function. Refer to page 39 for operation.

Time left until Lamp off.

Press the SET button at

this icon to display other

items.

Press the SET button at

this icon to display the

previous items.

Move the pointer to the

item and then press the

POINT LEFT/RIGHT

button(s).

SETTING