- ページ 38
プロジェクター Canon LV-5200のPDF オーナーズマニュアルをオンラインで閲覧またはダウンロードできます。Canon LV-5200 48 ページ。 Canon lv-5200: user guide
Canon LV-5200 にも： パンフレット＆スペック (2 ページ)
ページを印刷する
APPENDIX
When the life of the Projection Lamp of this projector draws to an end,
the LAMP REPLACE indicator lights yellow. If this indicator lights
yellow, replace the Projection Lamp with a new one promptly.
Allow the projector to cool, for at least 45 minutes before
you open the Lamp Cover. The inside of the projector
can become very hot.
Follow these steps to replace the lamp assembly.
1
Turn off the projector and disconnect the AC plug. Allow the
projector to cool for at least 45 minutes.
2
To remove the Lamp Cover, remove the screw with a
screwdriver.
3
Loosen 3 screws with a screwdriver and pull out the Lamp
Assembly by grasping the Handle.
4
Replace the Lamp Assembly with a new one and tighten 3
screws back into position. Make sure the Lamp Assembly is set
properly. Replace The Lamp Cover and tighten the screw.
5
Connect the AC Power Cord to the projector and turn on the
projector.
6
Reset the Lamp Replace Counter.
Refer to the "LAMP REPLACE COUNTER" on the next page .
ORDER REPLACEMENT LAMP
The Replacement Lamp can be ordered through your dealer. When ordering a Projection Lamp, give the
following information to the dealer.
G
Model No. of your projector
G
Replacement Lamp Type No.
38
LAMP REPLACEMENT
LAMP REPLACE
This indicator lights yellow
when the life of the Projection
Lamp draws to an end.
Replace the Projection Lamp
with a new one promptly.
For continued safety, replace with a lamp assembly of
the same type.
Do not drop the lamp assembly or touch the glass bulb!
The glass can shatter and may cause injury.
:
LV-5200
:
LV-LP16
(610 303 5826)
TOP CONTROL
Y
NE
US
WARNING
TEMP.
CAUTION
LAMP COVER
LAMP
SCREW
ASSEMBLY
LAMP
REPLACE
LAMP
SCREW
HANDLE