- ページ 10

リモコン Dotronix DOT-X SeriesのPDF ユーザーマニュアルをオンラインで閲覧またはダウンロードできます。Dotronix DOT-X Series 12 ページ。 Handheld addressable remote controls

SECURITY CODE

If you have changed the unit number from the factory setting, the current

number will appear where the 01 is shown above. To change the

number, key in the new number. Then press the ENTER key. If you do

not wish to change the number, simply press the ENTER key. Pressing

the ENTER key saves the number and makes it active for all future

operations requiring the unit number. It is not necessary to save the unit

number in a safe place since the unit will display its unit number on

screen whenever a unit number is required.

After pressing the ENTER key the on screen display is erased until

another selection is made via the remote control.

DE-ACTIVATING SECURITY

A jumper selection is provided on the HARC module to activate or de-

activate security. To access this jumper remove the rear of the monitor

and find the HARC module.

Jumper location, labeled J4 is located near the center of the module and

will have jumper installed on one pin of the jumper location in such a way

that there is no connection between the pins of the jumper location.

Moving the jumper from this non-active position to the position where it

covers and connects the two pins de-activates security.

CUSTOM OPTIONS

If the entered time is not the desired time, key in the desired number

again (and again if necessary) until the displayed time is correct. Then

press the ENTER key. Repeat for the new Stop time.

Pressing the ENTER key saves the displayed times and as the new

Start and Stop times.

After pressing the ENTER key the on screen display is erased until

another selection is made via the remote control.

Clock must be set correctly (see SETTING THE CLOCK) for ON/OFF

times to occur at entered settings.