Dotronix DOT-X Series Manual del usuario - Página 10
Navegue en línea o descargue pdf Manual del usuario para Mando a distancia Dotronix DOT-X Series. Dotronix DOT-X Series 12 páginas. Handheld addressable remote controls
Imprimir páginaSECURITY CODE
If you have changed the unit number from the factory setting, the current
number will appear where the 01 is shown above. To change the
number, key in the new number. Then press the ENTER key. If you do
not wish to change the number, simply press the ENTER key. Pressing
the ENTER key saves the number and makes it active for all future
operations requiring the unit number. It is not necessary to save the unit
number in a safe place since the unit will display its unit number on
screen whenever a unit number is required.
After pressing the ENTER key the on screen display is erased until
another selection is made via the remote control.
DE-ACTIVATING SECURITY
A jumper selection is provided on the HARC module to activate or de-
activate security. To access this jumper remove the rear of the monitor
and find the HARC module.
Jumper location, labeled J4 is located near the center of the module and
will have jumper installed on one pin of the jumper location in such a way
that there is no connection between the pins of the jumper location.
Moving the jumper from this non-active position to the position where it
covers and connects the two pins de-activates security.
9
CUSTOM OPTIONS
If the entered time is not the desired time, key in the desired number
again (and again if necessary) until the displayed time is correct. Then
press the ENTER key. Repeat for the new Stop time.
Pressing the ENTER key saves the displayed times and as the new
Start and Stop times.
After pressing the ENTER key the on screen display is erased until
another selection is made via the remote control.
Clock must be set correctly (see SETTING THE CLOCK) for ON/OFF
times to occur at entered settings.
14