- ページ 16

アクセサリー Baumer DENEX Gripper LEDのPDF ユーザーマニュアルをオンラインで閲覧またはダウンロードできます。Baumer DENEX Gripper LED 24 ページ。

ACCESSORIES AVAILABLE FROM DENEX

There are a number of accessories available from Baumer that can save you time and

ensure a good operation of the sensor. Kits for replacing mechanical or older sensors are

available. See web site

information.

9.1

Order a Ferag Finger to Gripper LED Conversion Kit from Baumer to make the installation

quick and easy.

For TTR: Part. No. 11084181 (formerly 51G6040) or

For UTR: Part. No.11084159 (formerly 51G6050)

Full instruction is included in the kit containing bracket and cable.

Check the type (NPN or PNP) of Ferag-Finger that is used.

Check the type (NPN or PNP) of Baumer that is used.

Wire according to chapter 5.

• If the output is inactive (0V on the output) when no papers are present and the Baumer

is inactive when no Gripper is close to it Use Mode 2.

• If the output is active (LED is ON at the Finger) when no papers are present and the

Baumer is inactive when no Gripper is close to it Use Mode 3.

• If the output is inactive (0V on the output) when no papers are present and the Baumer

is active when no Gripper is close to it Use Mode 4.

• If the output is active (LED is ON at the finger) when no papers are present and the

Baumer is active when no Gripper is close to it Use Mode 5.

Wire the DENEX Gripper LED Output Cable either for current source or current sink,

depending on the Ferag input stage.

User Manual DENEX Gripper LED

Version 2013-02, V1.4

www.baumer.com

www.denex.com

16/24

www.baumer.com

for more updated

Baumer Electric AG

Frauenfeld, Switzerland