- ページ 16

アクセサリー Baumer GNAMG. 153P SeriesのPDF マニュアルをオンラインで閲覧またはダウンロードできます。Baumer GNAMG. 153P Series 19 ページ。 Inclination sensor with profibus-dp interface

7. Terminal assignment and commissioning

 Release both fastening screws of the bus cover.

 Carefully loosen the bus cover from the base plate and lift off in the axial direction.

 Firmly screw the base plate in place using the fastening holes.

 The bus cover must fully rest against the base plate. Any tolerances in mounting the bus cover onto the

base plate might affect the absolute inclination angle.

 Alignment of coordinates (y- / y+ / x- / x+) see following diagram.

Installation position – sensing range 15°, 30° und 60°

Baumer_GNAMG_Profibus_MA_EN

07.18

The two-dimensional inclination sensor with a sensing range of

15°, 30° and 60° must be mounted with the base plate in

horizontal position, i.e. parallel to the horizontal line.

The inclination sensor may also be installed upside down, i.e.

turned by 180°.

The sensor can be inclined both in lateral (X-axis) and

longitudinal (Y- axis) direction at the same time. For each

axis a separate measured value is provided.

As default parameter the inclinometer will apply the selected

sensing range to both the X and Y- axis, for example ±15° with

the zero passage being precisely in the horizontal line.

16/19

Baumer IVO GmbH & Co. KG

Villingen-Schwenningen, Germany