- ページ 10
ディスペンサー Dover HYDRO EvoWashのPDF クイック・スタート・マニュアルをオンラインで閲覧またはダウンロードできます。Dover HYDRO EvoWash 19 ページ。
ページを印刷する
programming
Program Mode
Program Mode is password protected (factory set to "123") with two sets of menus for installers and maintenance technicians
to adjust the unit settings to meet their wash requirements. Follow the steps below to access the Program Mode Menus.
1) Press and hold the Enter key
000
2) Use the Scroll key
to change the 1st digit.
1 2
000
6) Use the Scroll key
to change the 3rd digit.
Program Menu Settings (Program Menus 2, 3 and 4)
Program Menu 2 is considered the "Configuration Menu". It is accessible by entering the proper Program Mode password.
Whether you see Program Menu 3 or Program Menu 4 after Program Menu 2 will depend on the setting in Menu 21,
Detergent Control, where you set whether the controller will operate in "Probe Mode" or "Probeless Mode".
Program Menu 3 is considered the "Adjustment Menu" for Probe Mode.
Program Menu 4 is considered the "Adjustment Menu" for Probeless Mode.
Details for the individual configuration settings available in Program Menu 2 and the individual adjustments available in
Program Menus 3 or 4 are shown in the menu trees on the following pages. All the individual menu items are then described
on the pages after the menu trees.
10
for 2 seconds. (NOTE: Gray indicates blinking in displays below.)
3) Use the Next key
to move to 2nd digit.
1 23
000
7) When the proper password is displayed, press the
the Enter
key to access Program Mode Menus.
(The rest of this page was intentionally left blank.
Program Menu Trees begin on the next page.)
000
1
4) Use the Scroll key
to change the 2nd digit.
5) Use the Next key
to move to 3rd digit.
2
000
8) Program Mode Menu 2