- ページ 8

製氷機 Follett 230V 50HzのPDF インストレーション＆サービスマニュアルをオンラインで閲覧またはダウンロードできます。Follett 230V 50Hz 20 ページ。 230v 50hz ice and water dispensers

Installing remote icemaker

Correct installation of remote icemaker(s) is critical to proper performance of

icemaker and dispenser.

Check to make sure bin signal on icemaker control board is switched to 24 volt

connection.

Refer to installation manual packed with icemaker for important details on ice

transport tube run, ventilation requirements and other installation requirements.

Failure to comply with instructions will void warranty.

1. Position icemaker in desired location.

2. Push one end of ice transport tube(s) through hole(s) provided in side of dispenser.

3. Route tube into ice tube bracket inside dispenser and engage bracket tabs in holes located in end of ice

transport tube(s). (See drawings below.)

4. Proceed with ice transport tube installation from dispenser to icemaker in compliance with instructions

contained in icemaker installation manual packed with icemaker.

Ice tube retainer bracket

thermostat

(automatic load units only)

Front view

25mm

ice tube

Side view

ice tube

Tabs in ice tube

retainer bracket

engage holes in ice

tube and hold tube

in place

thermostat