Follett 230V 50Hz 설치 및 서비스 매뉴얼 - 페이지 8
{카테고리_이름} Follett 230V 50Hz에 대한 설치 및 서비스 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Follett 230V 50Hz 20 페이지. 230v 50hz ice and water dispensers
페이지 인쇄Installing remote icemaker
Correct installation of remote icemaker(s) is critical to proper performance of
!
icemaker and dispenser.
Check to make sure bin signal on icemaker control board is switched to 24 volt
connection.
Refer to installation manual packed with icemaker for important details on ice
transport tube run, ventilation requirements and other installation requirements.
Failure to comply with instructions will void warranty.
1. Position icemaker in desired location.
2. Push one end of ice transport tube(s) through hole(s) provided in side of dispenser.
3. Route tube into ice tube bracket inside dispenser and engage bracket tabs in holes located in end of ice
transport tube(s). (See drawings below.)
4. Proceed with ice transport tube installation from dispenser to icemaker in compliance with instructions
contained in icemaker installation manual packed with icemaker.
Ice tube retainer bracket
thermostat
(automatic load units only)
Front view
25mm
ice tube
Side view
7
ice tube
Tabs in ice tube
retainer bracket
engage holes in ice
tube and hold tube
in place
thermostat