- ページ 13

ストレージ AmpleNess S52200のPDF ユーザーマニュアルをオンラインで閲覧またはダウンロードできます。AmpleNess S52200 18 ページ。 Home energy storage system (split type)

Please take reference of the way recommended by manual to place the product. All devices

must be firm during installation. Please arrange the stacked number of devices

actual needs. Don't install batteries on sloping and unstable ground.

6.4.2 Ground wire connection

Please unscrew the screw at the ground hole on front panel, install the ground terminal on

the screw and tighten it with a screwdriver. The other end of ground wire is connected to the

nearby bracket, and the whole is connected to a reliable ground point.

Attention: the ground resistance ＜4Ω .

6.4.3 Power cable connection

Please check the continuity of the cable, distinguish the positive and negative terminals, and

label the cables before connecting power cable. Please also check whether there is short circuit

and reverse connection after the cable connection is finished. The checking method is as

follows:

Cable continuity: please adjust to the buzzer gear of multimeter and test two ends of the

cable by a probe. If the buzzer sounds, the cable is available.

Voltage diagnosis: please adjust to the DC voltage gear of multimeter and test the positive

and negative electrode of battery by a probe. If it indicates the voltage within the normal range,

the product can be used.

6.4.4 Cables connection

Please take reference of the following description of wiring method for installing battery

pack.

A single battery: please connect the positive electrode of battery with the DC positive

electrode of inverter by a red cable, and connect the negative electrode of battery with the DC

negative electrode of inverter with a black cable.

Multiple batteries: please adopt the parallel connection method between battery and battery

or battery and inverter. At first, please connect the positive terminals of the adjacent 2

batteries respectively by a red cable, and connect the negative terminals of the adjacent 2

batteries respectively by a black cable. Second, please connect the positive electrode of battery

with the DC positive electrode of inverter by a red cable, and connect the negative electrode of

battery with the DC negative electrode of inverter by a black cable.

Communication cable, please connect the CAN interface of battery with the communication

interface of inverter. The RS485 interface of battery is used for the communication connection

of two batteries.

User Manual of Home Energy Storage System (Split Type)

flexibly as