- ページ 5

カー・ビデオ・システム Caraudio-Systems RL-UCON22-TFのPDF マニュアルをオンラインで閲覧またはダウンロードできます。Caraudio-Systems RL-UCON22-TF 7 ページ。 Interface for activation of factory rear-view camera input for uconnect 5“ or 8,4“ system with 22 pin connector

ページを印刷する
Caraudio-Systems RL-UCON22-TF マニュアル
2.   Installation  
 
Switch  off  ignition  and  disconnect  the  vehicle's  battery!  If  according  to  factory  rules  
disconnecting  the  battery  has  to  be  avoided,  it  is  usually  sufficient  to  put  the  vehicle  is  
sleep-­‐mode.  In  case  the  sleep-­‐mode  does  not  show  success,  disconnect  the  battery  with  a  
resistor  lead.  
 
Notes:  The  interface  is  installed  on  the  backside  of  the  monitor  unit  
Cinch  plugs  on  the  harness  (red  /  white)  forward  the  factory  AUX  signal    
and  must  therefore  remain  connected.  Yellow  cinch  connector  (male)  have  no  function.  
 
2.1.  
Connecting  CAN-­‐Box,  harness  and  factory  navigation  unit  
 
 
 
 
 
 
Grey1female
 
22pin1connector
 
vehicle harness
 
 
 
 
 
4
 
 
 
 
2
 
 
 
White1female
 
22pin1connector
vehicle harness
 
 
Connect  female  8pin  Molex  connector  of  harness  TV-­‐DG22  to  male  8pin  Molex  
1
connector  of  CAN-­‐box  ZLC-­‐TV506.  
 
Transfer  white  female  22pin  connector  of  vehicle  harness  from  rear  of  the  head-­‐unit  
2
into  male  white  female  22pin  connector  of  harness  TV-­‐DG22.  
 
Plug  white  female  22pin  connector  of  harness  TV-­‐DG22  into  male  22pin  connector  on    
3
the  rear  of  the  head-­‐unit.  
 
4
Transfer  grey  female  22pin  connector  of  vehicle  harness  from  rear  of  the  head-­‐unit  
into  male  grey  female  22pin  connector  of  harness  TV-­‐DG22.  
 
Plug  grey  female  22pin  connector  of  harness  TV-­‐DG22  into  male  22pin  connector  on    
5
the  rear  of  the  head-­‐unit.  
Version  01.04.2015
 
CAN)Box1
ZLC)TV506
1
Harness
TV)DG22
Rear of
head unit
 
3
5
RL-­‐UCON22-­‐TF