Caraudio-Systems RL-UCON22-TF Руководство - Страница 5
Просмотреть онлайн или скачать pdf Руководство для Автомобильная видеосистема Caraudio-Systems RL-UCON22-TF. Caraudio-Systems RL-UCON22-TF 7 страниц. Interface for activation of factory rear-view camera input for uconnect 5“ or 8,4“ system with 22 pin connector
Печатать страницу
2. Installation
Switch off ignition and disconnect the vehicle's battery! If according to factory rules
disconnecting the battery has to be avoided, it is usually sufficient to put the vehicle is
sleep-‐mode. In case the sleep-‐mode does not show success, disconnect the battery with a
resistor lead.
Notes: The interface is installed on the backside of the monitor unit
Cinch plugs on the harness (red / white) forward the factory AUX signal
and must therefore remain connected. Yellow cinch connector (male) have no function.
2.1.
Connecting CAN-‐Box, harness and factory navigation unit
Grey1female
22pin1connector
vehicle harness
4
2
White1female
22pin1connector
vehicle harness
Connect female 8pin Molex connector of harness TV-‐DG22 to male 8pin Molex
1
connector of CAN-‐box ZLC-‐TV506.
Transfer white female 22pin connector of vehicle harness from rear of the head-‐unit
2
into male white female 22pin connector of harness TV-‐DG22.
Plug white female 22pin connector of harness TV-‐DG22 into male 22pin connector on
3
the rear of the head-‐unit.
4
Transfer grey female 22pin connector of vehicle harness from rear of the head-‐unit
into male grey female 22pin connector of harness TV-‐DG22.
Plug grey female 22pin connector of harness TV-‐DG22 into male 22pin connector on
5
the rear of the head-‐unit.
Version 01.04.2015
CAN)Box1
ZLC)TV506
1
Harness
TV)DG22
Rear of
head unit
3
5
RL-‐UCON22-‐TF